How do you replace the turbo on a Mazda CX?
1. Disconnect the throttle body connector. 2. Wrap a clean cloth around the cooling system cap and release the pressure by loosening the cap slowly. 3. Remove the water hose from the throttle body and plug the water hose quickly. 4. Remove the throttle body.
How do you remove an engine from a Mazda 3?
1. Secure the engine and transaxle using a commercially available engine lifter. 2. Remove the No.4 engine mount rubber. 3. Remove the No.3 engine mount. Retighten the No.3 engine mount stud bolts when the No.3 engine mount nuts are loosened 1. Tighten the No.3 engine mount stud bolts.
How to tighten studs on Mazda 3 engine?
Retighten the No.3 engine mount stud bolts when the No.3 engine mount nuts are loosened 1. Tighten the No.3 engine mount stud bolts.
How to remove air intake from Mazda 3?
Turn off the engine and wait until it is cool. Even then, be very careful when removing the cap. Wrap a thick cloth around it and slowly turn it counterclockwise to the first stop. Step back while the pressure escapes. When you are sure all the pressure is gone, press down on the cap using the cloth, turn it, and remove it.
1. Disconnect the throttle body connector. 2. Wrap a clean cloth around the cooling system cap and release the pressure by loosening the cap slowly. 3. Remove the water hose from the throttle body and plug the water hose quickly. 4. Remove the throttle body.
What should I do if my Mazda 3 engine is removed?
If the No.3 engine mount bracket and the engine are removed, retighten the No.3 engine mount stud bolts. 1. Tighten the No. 3 engine mount stud bolts. 2. Secure the engine and transaxle using an engine jack. 3. Temporarily tighten the No.3 engine mount installation bolts and nuts. Do not tighten the bolts during this step.
Turn off the engine and wait until it is cool. Even then, be very careful when removing the cap. Wrap a thick cloth around it and slowly turn it counterclockwise to the first stop. Step back while the pressure escapes. When you are sure all the pressure is gone, press down on the cap using the cloth, turn it, and remove it.
How to tighten engine mounts on Mazda 3?
Temporarily tighten the No.1 engine mount rubber installation bolts in the order shown. Tighten the bolts in the order shown in the figure to prevent abnormal noise and vibration after assembly. Tighten the bolts while being careful of their length to prevent interference between the steering gear housing and bolt.