How do you replace a trunk lock cylinder?

How do you replace a trunk lock cylinder?

Part 1 of 2: Removing the old trunk lock cylinder

1. Materials Needed.
2. Step 1: Pop the trunk and remove the trunk liner.
3. Step 2: Remove any actuating rods.
4. Step 3: Unbolt or unclip the lock cylinder.
5. Step 4: Remove the trunk lock cylinder.
6. Step 1: Install the new lock cylinder.
7. Step 2: Reconnect the actuator rod(s).

Can a trunk lock be fixed?

Anytime you place items in your trunk, you’ll want to know that they will be kept safe and secure. The trunk lock actuator makes sure this is a reality. This device typically is not repaired, as it’s more efficient for a certified mechanic to simply replace it with a new actuator.

How do you open Ag body trunk without a key?

you can open the trunk from outside the car without a key- you just need a screwdriver. flip the license plate down and pop out the clip that holds the lock cylinder in place and pull the cylinder out. then stick a long flat screwdriver in there and pop the latch.

Why is my automatic trunk not working?

It usually occurs if the module fails or if there is a loss of power. It can also occur if the batter is jumper improperly but most of the time you will have other issues also. If the battery was jumped correctly then I usually start by reprogramming the control module just to see if it will accept the programming.

Why will my trunk not open?

In most cases, that means the lock is broken or that there is some inherent fault that does not allow it to operate the way it was intended. This could be because the trunk latch, trunk lock, or other internal mechanisms responsible for the smooth operation of the lock, have now gone awry.

When do I need to replace my trunk key?

You may need to replace your trunk key lock if you have lost your trunk key or the lock has become worn or damaged. You need not purchase an entire lock assembly; you only need a new cylinder that has been machined to match your master car key. A locksmith can read the reference numbers on your old cylinder and find a new one for this purpose.

Obtain a replacement cylinder. Install your replacement cylinder by pushing it into the old lock. The pin on the new cylinder will automatically pop into the locked position to hold the cylinder in place. Reverse the steps above to reinstall the lock. Treat the inside of all of your keyed lock cylinders with a graphite spray once or twice a year.

How do you remove a trunk key lock?

Remove any interior body panels that prevent access to the trunk key lock. Use a flat-head screwdriver to pry out any clips or push snaps that hold the body panels in place.

Do you need to buy a new trunk lock?

You need not purchase an entire lock assembly; you only need a new cylinder that has been machined to match your master car key. A locksmith can read the reference numbers on your old cylinder and find a new one for this purpose.