How do you replace a sway bar on a Honda Civic?
There are five bolts securing each rear control arm in place. With sockets and a ratchet, remove the 17 and 19 mm bolts from the rear section of the control arm. Remove the old rear control arm section and replace it with a new one. Figure 2. Replace rear section of the control arm from the sway bar.
What to do if your sway bar is missing?
Inspect the center part of the bar, where it bolts to the chassis. Inspect the bushings underneath the brackets to ensure bushings are not damaged, torn or missing. If it is determined that the sway bar bushings need replacing, remove the sway bar with the appropriate tools.
Where does the bushing go on a sway bar?
The middle portion of a sway bar on a car bolts to the chassis. Bushings slide onto the bar and then a metal bracket goes over the bushing and the bracket bolts to the chassis. The sway bar is bolted to the suspension at either end with end links that come off the bar at 90-degrees.
How is a sway bar attached to a frame?
At the control arm, the bar is attached with sway bar links. In some cases, the bar may attach to the strut instead of the control arm. At the body or frame, the sway bar is attached with sway bar bushings. There are usually two sway bar bushings for each sway bar. Sway bar bushings isolate the sway bar from the body or frame to reduce noise.
How to replace front sway bar bushing and links?
This shows the new passenger side frame bushing on a 2001 GMC Jimmy. Lightly grease the bar, bushings, and mounts. Slide the bushing over the bar and cover it with the mount. Position and reattach the mount. Torque the nuts/bolts to specification. Grease as required.
What do I need to remove front wheel drive sway bar?
Remove the nuts holding the sway bar link to the bar and control arm. Remove the link. Link removal on some front-wheel-drive cars will require a ΒΌ-inch Allen wrench to keep the bolt from spinning.
How to get rid of bad sway bar links?
FASTEST WAY TO REMOVE BAD SWAY BAR LINKS…Bam Off! – YouTube If playback doesn’t begin shortly, try restarting your device.
How are sway bars attached to the car?
Sway bars contain body roll by twisting. To do this, they attach to the vehicle in four places: two frame attachment points and through two end links to the wheel. When you make a hard left turn, for instance, your car’s body is thrown to the right because the left side of the vehicle is trying to come off the ground.