How do you replace a steering gear box seal?
Process
- Disconnect the battery and lift the vehicle.
- Remove the power steering gear from the car.
- Clean the gearbox.
- Remove the input shaft face cover.
- Mark the cover and housing.
- Remove bearing cap bolts and cover.
- Pry the soft seal from the cap cover.
- Drive the input shaft seal with a seal driver.
Can you rebuild a steering gear box?
In most cases, a steering box needs rebuilding because it has become so loose that it is hard to keep the car going straight down the road without a lot of constant correction. The three most important parts in the steering box are the Input Shaft/Worm Gear, the Rack Block and the Sector Shaft.
How to replace Dodge Ram Power steering gear box?
’94-’02 Dodge Ram Power Steering Gear Box Replacement – Step by Step! If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
What do I need to rebuild my steering box?
There are two vital adjustments that need to be within spec when rebuilding a steering box. One is the worm shaft bearing load, and the other is the gear mesh load. The worm shaft is positioned between two caged ball bearings, and actually functions as the inner races for both of these bearings.
How do you remove an arm from a steering shaft?
Use a Pitman arm puller to remove the arm. Take your Pitman arm puller and remove the arm from the steering shaft. It will release from the shaft and drop down some, but the arm is still being held up by the centerlink.
How do you replace a cotter pin on a steering box?
Put some antisieze grease on the steering box’s tapered bolt. Pack grease up into the steering box around the top of the tapered bolt. This will help keep out dirt and moisture. Prepare a new cotter pin by cutting down the length of one side to match the one you removed.