How do you replace a rear wheel bearing?
1. Remove the wheel hub and knuckle assembly. Refer to Knuckle Replacement. 2. Secure the wheel hub and knuckle assembly using a suitable vice. 3. Remove the wheel speed sensor to knuckle retaining bolt (2). 4. Remove the wheel speed sensor (1). Note:€The wheel bearing will be damaged when pressing out the wheel hub flange.
How to replace the rear hub bearing on a Ford Explorer?
Loosen the lug nuts from the wheel which the bearing is going to be replaced. Step 2: Raise and secure the vehicle. Raise the vehicle and secure it on jack stands, and then remove the wheel. Place blocks of wood underneath the front and rear of the wheel diagonally opposed from the one you will be working on.
How to service or change bearings on a formula rear hub?
I had a generic Formula hub and had to get, I think, an 11mm key to unscrew the freehub. Rest of it is just like most hubs, knock/pull the bearings, push new ones in. Hubs are normally either push fit (e.g. Hope) or the axle has some form of threading holding the end caps one. Take the cassette off and inspect the axle.
Where do you insert a hub unit bearing?
Hub Unit Bearing Installation. Insert the new hub assembly into the steering knuckle. Check the positioning of the splines on the axle shaft while inserting the hub assembly. Never force the hub assembly on the shaft or strike with a hammer.
How much does it cost to replace front wheel bearings?
If the bearing is sealed, it can lead to more work such as replacing the hub as well; however, a permanently sealed bearing means they can last longer, oftentimes, as long as the car. For the parts alone, wheel bearings can cost anywhere from $20 to as much as $200.
How do you change wheel bearings?
To change wheel bearings, start by lifting the wheel up on a jack, unscrewing the lug nuts, and taking the wheel off. Then, remove the brake caliper, the dust cover over the rotor, and the cotter pin and castle nut behind the dust cover.
How do you remove a wheel bearing?
Remove the wheel bearings from your car wheel. Place a ball of grease in the palm of one hand. You may want to wear a pair of rubber gloves to protect your hands. Push the bearing into the grease with your other hand. Push in the large end first so that the grease gets forced into the inner parts of the bearing.
How do you install front wheel bearings?
Steps Park your vehicle on a flat surface. Use wheel chocks to secure wheels whose bearings you aren’t replacing. Loosen the lug nuts and lift the wheel using a jack. Unscrew the lug nuts and remove the wheel. Remove the brake caliper. Remove the dust cover, cotter pin, and castle nut. Remove the rotor. Unscrew the hub bolts and remove the old hub.