How do you replace a rear main seal?
Raise the car with the help of a jack so that it becomes easy to reach the rear main seal. Keep the toolbox near you and make sure that you have every essential tool in it. It’s time to start with the first step.
What should I do after replacing my rear axle?
After the axle has been reinstalled use a gasket scraper to remove the old gasket and clean the differential surface. Make sure this surface is clean from gear oil or it will contaminate the sealer and possibly cause a leak. Use a shop towel to wipe out the inner differential housing to help control additional oil.
How to replace rear automotive axle bearings 1 ton?
Before you begin, park your car on level ground with the transmission in park. You will need to raise up your car with a floor jack and secure it using jack stands for safety and then remove and reinstall the wheel. Remember safety first, never get under the vehicle unless jack stands are in place.
What kind of front wheel should I repair?
The wheel I repaired is a rear 700c road wheel, but the principles here apply to the front as well as other styles and sizes. If it is front wheel you are repairing, try to ignore the emphasis on the drive versus non-drive sides, just make sure to switch sides when called for. If you have done any truing you should already have this one.
What’s the best way to replace a wheel assembly?
Grab the jack, place it in the correct spot under the vehicle, and jack the car up until you can remove the jack stands. Then you can lower the vehicle back onto the ground. Step 8: Torque the wheels.
What’s the best way to replace a driveshaft support?
Step 1: Prepare the vehicle for working. Use a floor jack to raise the vehicle to a height that will allow easy access to the driveshaft while using your tools. Jack one wheel at a time and place jack stands underneath solid mounts for support. Once the vehicle is secured make sure you have enough light to see underneath the vehicle.
Raise the car with the help of a jack so that it becomes easy to reach the rear main seal. Keep the toolbox near you and make sure that you have every essential tool in it. It’s time to start with the first step.
How do you replace rear suspension bushings on a car?
First, jack the rear of the car up and place it securely on jack stands. Place the floor jack underneath the suspension and pump it up to support the weight — in the center of the beam, or underneath the end of the suspension arm if you have independent suspension.