How do you replace a brake light on a Ford Explorer?
Place the bulb in its respective place on the lens, and secure it by giving it a quarter turn. Attach the lens to the vehicle, making sure all the wires are neatly tucked in. Secure the side with the plastic pegs first. Then replace the screws. Check lights, back-up lights, brake lights and turn signals to make sure everything is working properly.
How do I install a new brake light bulb?
Remove the old bulb. Install the new bulb and you will need to ensure it’s orientation is correct so you basically have a 50/50 chance on this. Test the bulb by turning on the parking lights or activating the brake lights, if it doesn’t work, then turn the bulb around.
How to adjust the brake light switch on a car?
1 Adjust Brake Light Switch (if there is room.) 2 Brake Light Fuse 3 Brake Light Stopper / Bumper Pad 4 Brake Light Wire Harness More …
Why are the brake lights not working but the tail lights are?
Blown out light bulbs are the most common reason for why the brake lights not working but the tail lights are. Remove the screws from the bulb lens (which you can access through the trunk or see your vehicle repair manual to get the exact location). Push the bulbs and turn them counterclockwise to remove from the socket.
How do you replace a brake light bulb?
Identify and remove the brake light socket. Twist and pull the socket to pop it out. Remove the bulb. On some vehicles, you have to twist and pull to get the bulb out, but in most vehicles the bulb can just be pulled out. Check to make sure the electrical contact where the bulb fits in the socket is not burned.
Can a brake light switch not be installed?
In many cars, there is a special procedure to remove and install the brake light switch. If not installed correctly, the switch will not operate and can even be damaged. In some cars, the gap between the brake pedal and the switch must also be adjusted.
How can I tell if my brake light bulb is failing?
The easiest way to check your brake lights without an extra leg laying around would be to set a brick or something heavy enough on the brake pedal to trigger the brake lights to come on. If the brake light is slow to come on, is dimmer than usual, or the Brake Warning Light comes on, then your brake light bulb may be failing.
How do you test the brake light switch?
In some cars, the testing procedure involves testing the voltage at the brake light switch connector when the brake pedal is depressed and released. In other cars, the service manual recommends testing the switch continuity with the pedal depressed and released. If there is no voltage at the brake switch,…