How do you replace a 12 volt alternator?
Once you have determined that the new alternator is the correct replacement for your existing model: 1. Disconnect the batteries and/or turn the switch to the “OFF” setting. Disconnect the wiring from the existing alternator. 2. Loosen the mounting & tensioning bolts and remove the existing alternator. 3.
How do you remove an alternator from a Balmar car?
Disconnect the batteries and/or turn the switch to the “OFF” setting. Disconnect the wiring from the existing alternator. 2. Loosen the mounting & tensioning bolts and remove the existing alternator. 3. Once the alternator is disconnected from the engine, compare its mounting points to those on your new Balmar alternator.
What should I do if my alternator is not working?
Listen for odd noises, the smell of burning plastic, or the sight of smoke. You can bring the vehicle to AutoZone and have the alternator tested on the vehicle to ensure the charging system is performing correctly. Some of these steps may vary slightly depending on your exact year, make, model, and engine.
How do you install a belt on an alternator?
To install the belt: 1. Loosen the adjustment arm bolt and alternator pivot assembly bolt. 2. Fit a new, high-quality belt over the appropriate pulleys. 3. Tension the alternator until the belt is securely tightened in place. Re- tighten the pivot assembly and tension arm bolts.
How do you remove an alternator?
Removing the Old Alternator Relieve tension on the belt with the auto-tensioner (if equipped). Loosen the bolts on the alternator if there is no auto-tensioner. Inspect the serpentine belt for damage. Remove the alternator from the engine bay. Compare the new alternator to the old one.
How do I replace the altenator?
How to Replace Your Alternator Disconnect the Negative Battery Cable. This step is crucial if you want to avoid a short, and trust us, you do. Locate the Alternator. The alternator is mounted to the engine, either the front or the side depending on the vehicle. Alternator Removal Match it Up! Alternator Installation. Finishing Up.
How do you install an alternator?
How to Install an Alternator in 10 Steps Step1 – Disconnect the Negative Terminal of the Vehicle’s Battery Step 2 – Loosen the Two Bolts that Hold the Alternator Step 3 – Rotate the Alternator Step 4 – Remove the Electrical Wires Step 5 – Adjust the Bolts Step 6 – Install the Belt Step 7 – Position the Alternator Step 8 – Move the Vise Grip