How do you remove the wheel hub spindle from a Toyota?
Using a shop press, press out the wheel hub spindle from the bearing. Make sure you use the appropriate size Toyota front wheel bearing tool (we are using a large socket) only pushing on the wheel hub spindle.
How do you remove a hub from a Toyota Aisin?
Remove the cover, the gasket, and separate the hub body from the rotor (for a complete explanation of removing and replacing hubs, see the article Toyota Front End Maintenance – Disassembly ). When the hub body is off, pull the clutch and tension spring from the body, and remove the spring from the cover.
How do you tear down a manual hub?
The first step in tearing down the manual hub is to remove the hub cover. With the hub set to “Free”, remove the six 10mm bolts which hold the cover on to the hub body.
How to remove a locking hub from a truck?
You will need 10 and 12mm sockets to remove the locking hub from the truck, and a small punch or screwdriver and a hammer are a help in removing the cone washers. Pic 1. There are 17 parts (gasket not pictured) in the locking hub.
Where is the hub on a Toyota Corolla?
On a Toyota Corolla, the assembly is located in the center of the steering knuckle, which must be removed to access the assembly. If you don’t have access to a hydraulic press, machine shops can remove the hub and bearing assembly and install the new assembly for a fee. Loosen the hub nut over the drive axle with a socket wrench.
How to replace front wheel unit bearings in Toyota 4×4?
You have two options for doing the job: 1st is to buy pre-assembled unit bearings. These are new bearings, seal and 4 bolts with a new wheel hub spindle already pressed into the wheel bearings. This is a direct just swap out the unit bearing and cost about $100 more per side.
When did Toyota stop using manual locking hubs?
Toyota used the exact same hubs from 1979 – 1985 trucks ( Hilux ) and 4Runners with only minor changes from 1986 – present. Loading…