How do you remove the speakers from a car?
Remove the screws mounting the speakers to the door. Pull each speaker out and disconnect the module from the rear of the speaker. Some older vehicles have wiring soldered to the speaker, rather than a connection module.
What do I need to remove front door panel?
Both sizes will require a bracket in order to fit properly since the factory speakers are an odd size. To remove the door panels and speakers you’ll need a Phillips head screwdriver and also a flathead screwdriver.
How do you remove the Speaker from a Honda Fit?
To remove the speaker from the door take out the screw and then gently pull on the speaker until the sticky foam on the back side gives way. The power connector on the back of the speaker can be released by squeezing together the two clips and pulling the connector straight off the speaker.
What’s the best way to remove a door grille?
Use the trim tool or a small flathead screwdriver to pop the grille cover off and access the speaker. Follow the same procedure for disconnection as the door speakers. If you don’t plan on installing new speakers, wrap the open end of each wire with electrical tape before replacing the panels or grilles.
What’s the best way to remove a door panel?
Pry out the small rubber cover in the door handles grab cup. Be sure to use the plastic removal tool so that you don’t scratch anything. Peek-a-Boo! There’s the first one. Using your T30 bit, remove this bolt. You will then use the thin part of your plastic panel removal tool to pry the plastic control panel out of the door.
How to install speakers in a Jeep Renegade?
This tutorial will cover the removal of the door panels and installation of 6×9 speakers in the Jeep Renegade with 6 speaker system. The speakers are being powered from the stock head unit. If I feel the need to amplify them down the road, at least this part is out of the way.
How to remove front door trim on AU Falcon?
Au falcon front door trim removal. Fitting new speaker. If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. DIY mechanical. A bit of this and that.
How can I change the speaker on my front door?
Remove the speaker cable from the existing speaker. Using a 5mm drill bit, drill the top from each securing rivet. Remove the speaker from the door (Laugh out how crap it is). Using a 3mm drill bit, drill out the remains of the pop rivets. Brush the swarf / remains of the pop rivets out of the internal door though the drain hole at the bottom.
How do you remove a stereo speaker grille?
In my speaker model, the speaker to the horn was attached to the molded plastic speaker grille and had to be removed (two phillips-head screws). One cone speaker was then removed, by removing four phillips-head screws, and gently pried off with the sharp, broad-face wood chisel, until it released from a foam gasket-seal.
How to remove Pop Rivets from front speakers?
Using a 3mm drill bit, drill out the remains of the pop rivets. Brush the swarf / remains of the pop rivets out of the internal door though the drain hole at the bottom. Cut the existing speaker cables plug off. Strip back each wire to expose the inner core.