How do you remove the rear section of a Jeep Wrangler?
It is highly recommended that you do not try to take the rear section off by yourself unless you have a hoist or other system in place. Once you have some help, lift up from the center of the top and pull back. That’s it! Make sure to place your Jeep Wrangler hardtop in a safe and secure place when it’s not in use.
What’s the best way to remove a jeep hardtop?
Compared to other Jeep hardtop hoists on the market, the TopLift Pro provides the simplest solution for easily removing and reinstalling your top in a matter of minutes without requiring an entire team of helpers to get the job done. There’s really no comparing the capabilities of the TopLift Pro to other Jeep hardtop storage solutions.
How do you change rotors on a jeep?
If you are changing rotors, they are held in place by o-rings to the hub (my guess is for building at the factory). You will have to use force to get them off, I used a rubber mallet to the backside while being careful of the splash-guard.
Do you need to take top off Jeep Wrangler?
Before you can pop your top off your Wrangler, you’ll want to remove or disconnect all the securing points. Set aside a few containers or labeled bags to organize all the bolts and connectors that you’ll be removing to make it easier to reconnect your hardtop later.
If you are changing rotors, they are held in place by o-rings to the hub (my guess is for building at the factory). You will have to use force to get them off, I used a rubber mallet to the backside while being careful of the splash-guard.
How to remove the caliper mount on a jeep?
External Torx E-20 to remove (2) single use caliper bracket bolts–order (4 [to complete both sides]) 06510023AA From dealer in advance. Note: three of mine came out with my impact gun @ 90 psi.
Is there a reset tool for rear brake pads?
Brake pad design configuration may vary slightly, but the concept is the same. A rear caliper reset tool is necessary for parking brake integrated systems. The reset tool screws the piston back into the caliper. These calipers cannot be compressed with a clamping tool, it can only be reset with the reset tool.
What do you need to do a brake job on a jeep?
After that the pads will pull out, or you will need a small pry bar wrapped in tape to push between the rotor and pad to create room so you can pull them out. After this you can push the pistons in by hand, really. Two notes, and serious ones at that.