How do you remove the radio from the dash?
Push the radio forward; drop the end down, and rotate the radio assembly to remove it from under the dash. The heater control is held in place from the back side of the dash by two retainers, one on each side, as shown in photo #6.
How do you remove the heater on a Thunderbird?
With these items removed insert the small end of the bezel tool (photo #4) over the shaft and engage the bezel nut, turn counter-clockwise to remove. The cable assembly can then be removed by pushing the shaft housing forward and out from under the dash. The heater on/off switch is removed in the same manner.
How do you remove a headlight control switch?
We’ll start the removal procedures with the headlight control switch. The first step is to remove the Headlight knob and shaft from the headlight switch unit. Removing the knob and shaft will provide access to the headlight retaining bezel.
How do you remove a light switch from a Thunderbird?
The switch can be moved forward then dropped down from the dash enough to disconnect the wiring and remove the switch. The lighter assembly can be removed by going under the dash to disconnect the power wire, then turn the sleeve housing (under the dash) counter-clockwise to remove it.
Push the radio forward; drop the end down, and rotate the radio assembly to remove it from under the dash. The heater control is held in place from the back side of the dash by two retainers, one on each side, as shown in photo #6.
With these items removed insert the small end of the bezel tool (photo #4) over the shaft and engage the bezel nut, turn counter-clockwise to remove. The cable assembly can then be removed by pushing the shaft housing forward and out from under the dash. The heater on/off switch is removed in the same manner.
We’ll start the removal procedures with the headlight control switch. The first step is to remove the Headlight knob and shaft from the headlight switch unit. Removing the knob and shaft will provide access to the headlight retaining bezel.
How do you remove ignition switch from Thunderbird?
The bezel removal tool has two different size ends. The larger end is for removing the ignition switch bezel; the small end removes the headlamp switch, wiper controls and heater switch. The following procedures require going under the dash. Before starting disconnect the battery. Be sure to record the wire color codes and locations.
How do you remove the headlight shaft on a Thunderbird?
Photo #3 shows the Headlight knob and shaft after its been removed. With the shaft removed, the retaining bezel can be removed with the special tool by inserting the small end of the tool in the bezel slot and turning counter-clockwise.
How to remove the dash from a car?
1. the first step is to remove the inst cluster cover. I have circled the areas where the philips screw will need to be removed. After these screws are out, simply pull the cover towards you, and lift up and it’ll come straight out. 2. The next step is to remove the dash pad. This shot is from the bottom.
How do you remove a Philips dash cover?
1. the first step is to remove the inst cluster cover. I have circled the areas where the philips screw will need to be removed. After these screws are out, simply pull the cover towards you, and lift up and it’ll come straight out. 2. The next step is to remove the dash pad.
How do you remove a dash harness step by step?
Reach behind and feel the tab on the speedo cable (I have it circled below). Pushing on this tab will allow you to release and pull the speedo cable out. After that, the inst cluster will pull out a little more where it will show you the two main harnesses you must remove next.
How do you remove instrument cluster from Chevelle?
Remove the Original Instrument Cluster from the Dash 1) Remove the dash pad. 2) Remove the four screws fastening the lower steering column trim piece with a Phillips screwdriver. 3) Remove the two nuts that hold the steering column in place. 4) Lower the steering column. Take note if any shims are on the column mount. a.
How to remove the trim from the centre console?
Turn on the ignition, but not the engine (if it’s running, turn it off, and turn the ignition back on). Hold the brake pedal down, and put the gear lever in D (Drive). Turn off the ignition, and get cracking… Lift the gear lever gaiter surround, ideally using a plastic flat-bladed trim removal tool.
How do you remove the center console on a 2005 Honda C6?
Pull up the emergency brake boot in the front and it will reveal two 7mm screws holding the side trim plate on. Remove the two screws and pull down the side trim plate away from the dashboard. The clips will pull out of the dashboard. 2. For 2005-07 consoles, lift up on the back of the small trim plate (tombstone shaped).
How to get rid of the dashboard on a Silverado?
Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. I do videos about things with motors, mostly DIRT BIKES! Subscribe to check them out! 2019 KX450 at Sand Mountain! An error occurred while retrieving sharing information. Please try again later.
How do you remove the dashboard from a Chevy Colorado?
Pull off the air conditioning vent controls with your hand. Have a friend help you to remove the dash by lifting on both sides. Once the dash pops off, you will have a few electrical connectors to disconnect before it can be fully removed. Lift the driver’s side dash first, to lift the dash over the gear shift lever.
How do you remove a dashboard air vent?
Remove the four air vents on the dashboard. Turn the vents to the left and pull to remove them. Locate the two screws underneath near the hood release. Remove the screws to take off the panel below the steering wheel. Remove the four bolts mounting the instrument cluster in place.
What’s the best way to remove dash panels?
If you are removing the bezel around the stereo and environment controls, look to the bottom or top for a lip you can grip with your fingertips. In extreme cases, you may need to use a flat head screwdriver, but this greatly increases your chances of damaging the trim.
Can you remove dash trim from a car?
With no visible fasteners and the breakable nature of plastic, many shy away from dash trim removal. However, if you find yourself in a situation where you must undertake the disassembly of your dash trim, with a few tricks executed with patience and care, you can have your dash trim removed in no time.