How do you remove the passenger side dash?
Pull the bottom of the passenger-side dash off by hand, by pulling up and then out. Go to the driver’s door and locate the eight screws that go along the side of the driver-side dash. Remove the screws and keep them somewhere safe. Go to the passenger side and remove the eight screws that hold the dash in on that side.
Is the dash pad on the passenger side removable?
The passenger side lower dash pad is built into the dash top frame for 90-93 and is not a separately removable piece. The 94-96 versions are a vinyl covered removable piece. These are color matched to the interior of the car.
Where are the trim panels on a car?
Remove the two trim panels that run along either side of the stereo system. Start at the bottom (beside the gear selector lever), and pry the panels with a trim removal tool or flat screwdriver. Remove the panel under the steering column. Grab the panel near the driver’s-side door and pull it free from the dash.
How to remove the trim from the dash of a Volvo?
Instrument Panel and Dash: Heater Control Trim Removal. [Tip: Peter Gotseff] Start from inboard side (heater control unit side) rock up and down and pull gently to unclip the upper and lower right side panel clips.
The passenger side lower dash pad is built into the dash top frame for 90-93 and is not a separately removable piece. The 94-96 versions are a vinyl covered removable piece. These are color matched to the interior of the car.
Where are the dash pads on a 1990 Corvette?
The 1990-1993 dash top pads are a much larger piece that wraps completely around the top and bottom of the passenger side of the dash. The passenger side carpeted section (color matched to the interior) of the 1990-1993 dashes is part of the dash top pad and is not able to be separated.
What’s the difference between 1994 and 1996 Corvette dash panels?
The 1994-1996 dash panels are very similar to 1990-1993 designs with only minor changes. Most notably is the addition of the passenger side air bag, which takes the place of the glove box, used in the 1990-1993 versions. The shaping around the A/C controls and radio was also redesigned which allowed better visibility from the passenger seat.
What’s the name of the dash on a 1984 Corvette?
One of the most unique designs of the 1984-1989 dashes is the passenger side pad, commonly referred to as the “Breadbox”. Some people like them and some people hate them. There are aftermarket delete kits available for the breadbox which convert the area to just a flat plate but retains the opening for the dash vent.
How do you disassemble a jeep dashboard?
Pry the trim pieces of the dashboard off with the flathead screwdriver then remove the vents in the same manner. Unbolt the top portion of the dash with the socket wrench.
How do you remove the radio from the dash of a Pontiac?
The bolts are located right along the side of the dash and will run up the edge. Use a screwdriver to unfasten the radio bracket to remove the radio. Unhook all electrical wiring from the back side of the radio. Slide the radio straight out of the dash of the car.
How do you remove the dash on a Pontiac Aztek?
Shift the Pontiac Aztek into Park and pull the emergency brake up to keep the car steady while you work on it. Pry the rubber bottoms in the two center cup holders out with a flat head screwdriver. This exposes the Phillips screws on the bottom of each. Unscrew them with a Phillips head screwdriver and place them to the side.