How do you remove the dashboard from a Miata?
Tools: Phillips screwdriver • Work gloves 1. Remove the 2 phillips screws located at the front bottom of the cover, flanking the steering column. 2. Using work gloves for grip, grab each side of the cover and GENTLY move it back and forth, while pulling towards you, to unclip the 3 hidden clips holding it to the dash.
How can i dim the lights on my dashboard?
Begin the process by trying the simplest of solutions first. Most vehicles have a dashboard lights control switch that will dim the dashboard lights, as well as turn them off. Check the control switch, which should be located on the console near the steering column or part of the headlight switch.
What to do if your dash light does not work?
#Test the dashboard light bulbs. If the fuses are working properly, check for a blown bulb in the dashboard. Following the manufacturer’s instructions, disconnect the battery while working on the dash, remove the faceplate covering your vehicle’s dashboard gauge panel. Remove the screws holding the plate on. Carefully remove the faceplate.
How do you eject a CD from a Dodge Grand Caravan?
While the car is off, hold the power and the eject button. Press your CD player’s power and eject buttons down at the same time, holding them for about ten seconds. If your stereo has a “force eject” feature, it should spit out the CD.
How do you remove the radio from the dash?
Unplug the radio harness and antenna cable from the radio and pull it out of the dash. Leave all wiring under the dash. Next locate and remove four 3/8-inch nuts securing the heater controls to the rear of the pad. I prefer to leave these controls intact so I remove them from the pad and simply let the assembly hang.
How do you put a dash pad on a Pontiac?
It is held in place with a pressure clip. Push the clip in at the bottom and pull the cable out from the back of the gauge cluster. Remove two 9/16-inch bolts from each lower corner of the pad which secure it to the car and two more on either side of the steering column hole. You can now pull the pad forward enough to see behind it.
How do you remove the radio from a Pontiac?
Remove two 9/16-inch bolts from each lower corner of the pad which secure it to the car and two more on either side of the steering column hole. You can now pull the pad forward enough to see behind it. The radio is removed next. Pull off the buttons and bezels and remove the 5/8-inch nuts from the control shafts.
Can a Pontiac GTO be restored to just dashes?
The arm rest pads on this ’70 GTO convertible had seen better days, so they will be treated to Just Dashes vacuum forming process and restored at the same time as the dash. Almost any vinyl covered part you can remove from the car can be restored by Just Dashes, including door panels, head rests, etc.