How do you remove a third row seat in a Mercedes Benz?
Take it to the dealer. The third row seat (the three wide) has to be moved up to the middle of the van and taken out the side doors. It is too big to rotate to remove through the rear. The third row seat (the three wide) has to be moved up to the middle of the van and taken out the side doors. It is too big to rotate to remove through the rear.
How do you remove bench seat on ProMaster?
Removing the seats begins with disconnecting the negative terminal from the van battery so nothing crazy happens. This is an important step! Next you disconnect the wires underneath each seat. For the passenger bench seat there are two sets. We’ll get into that more. From there it’s quite simple to unbolt the entire seat.
Do you need a second person to remove the seat?
A second person is not absolutely mandatory (I didn’t have one for these pictures) but it makes it much easier. Step one, you pull this handle upwards, there is one for the whole seat, which unlatches the seat at the rear latches.
What happens when you remove the second row seat on a Metris?
After you remove the second row seat, the third row just needs to be unlatched and “walked” out of the track and then walked up to the second row track. If you can figure out a way of storing the second seat somewhere in your garage, the rear stowage area is “yuge”!
How to change second row captains chairs to bench seat?
1. Obtain a bench seat (60 and 40 sides), a few extra seat bolts, and the appropriate plastic trim. 2. Remove the plastic trim pieces around the seat tracks. 3. Remove the bolts holding each seat in place. I used an air ratchet/impact wrench. 4. Remove the captains chairs. Get help from a buddy so you don’t hurt yourself or the car. 5.
How can I get a bench seat for my traverse?
I picked up a bench seat, seat bolts and trim pieces from a 2014 Traverse in excellent condition from a salvage yard for $200. Basic steps and pictures below. 1. Obtain a bench seat (60 and 40 sides), a few extra seat bolts, and the appropriate plastic trim. 2. Remove the plastic trim pieces around the seat tracks. 3.
How do you install a driver’s side seat?
Install the driver’s side (60) seat and align the holes. Install bolts in all locations. Note that the right side mounting pads of the driver’s side (60) seat will install on top of the left side passenger side (40) seat. 11.