How do you remove a shock mount on a motor home?
Remove the upper shock mount bolt by turning it counterclockwise, then sliding it out of the shock’s eyelet mount. Some motor homes could have a shock mount plate, which can be removed by turning two vertical screws counterclockwise, then pulling the plate free. Once the top mount is loose, remove the lower mount nut.
How do you put a new shock on a suspension?
Fit the new shock back onto the suspension control arm. You might need to use some pressure to constrict the shock as it falls into place, and you might need a help to help lift the suspension back up to reinstall the bolts in the correct positions. It can be kind of a balancing act, so it helps to have another set of hands.
How do you remove a shock mount nut?
Turn the lower shock mount nut counterclockwise until it is loose, but do not remove the nut at this time. Remove the upper shock mount bolt by turning it counterclockwise, then sliding it out of the shock’s eyelet mount.
How do you remove a shock retaining bolt?
Remove the upper shock retaining bolt using the socket. You can also use the threaded rod with a separate tool to stop the rode from spinning. Then, remove the bottom shock bolt and give it a few taps with a hammer. Step 6: When you are doing the whole process, protect the threads or use new hardware.
What kind of shocks do I need for a Magna wagon?
Note that the rear shocks for a Magna sedan are different, and will cost more than the rear shocks for the wagon, due to a different rear suspension. spring compressors (for disassembling front struts) large screwdriver (for removing brake hose clip on front struts) axle stands (for supporting the car while replacing the front struts)
How long does it take to replace rear shocks on TJ Magna?
axle stands (for supporting the car while replacing the front struts) car ramps (for supporting the car while replacing the rear shocks) Installing the new struts on the front of my Magna took about 1.5 hours, while installation of the rear shocks only took about half an hour. Never work underneath a car that is only supported by a jack.
How do you install KYB shocks on a TJ Magna?
The KYB installation instructions recommend removing and replacing the strut on one side before removing the second strut. Remove the front wheel, and unbolt the ABS sensor wire on the rear of the strut. Using a large screwdriver, remove the clip that retains the brake hose in the strut. Remove the two strut-to-steering knuckle nuts.
What happens when you replace struts on a Magna?
Removing and replacing the struts is likely to affect the toe-in and camber of the front wheels, and this will affect tyre wear if it is not corrected. Note that this information describing the replacement of rear shocks is specific to the Magna wagon, as the Magna sedan has a totally different suspension geometry.