How do you remove a seat belt clip?
Remove the seatbelt buckle mounting bolt with a socket and wrench or Torx wrench. Turn the bolt counterclockwise until it can be removed from the mounting hole. Remove the old seatbelt buckle from the vehicle.
Do you need to remove a seat belt retractor?
If you need to remove your seat belt retractor or pre-tensioner out of your vehicle, this video will show you how to do that step by step. If your car has been in an accident or a crash, we can repair your seat belts!
Where is the latch on a seat belt?
Latch The only piece of seat-belt equipment to your right (if you’re in the driver seat), this doohickey usually is fastened to the floor and locks in the rest of the seat belt, keeping you in place in the event of a collision. The part that snaps into the latch. This system draws back the seat belt to keep it firm while you’re driving.
Where can I get a seat belt repaired?
Safety Restore is the leader in post-accident restoration, specializing in resetting SRS airbag modules with crash data and had codes as well as repairing locked & blown seat belt and buckle pre-tensioners. To place an order, visit http://www.safetyrestore.com 40 MAIN ST.
Where is the adjuster located on a seat belt?
Stationed over your left shoulder where the belt attaches to the door pillar, this part allows you to move the highest part of the belt up or down. The adjuster is essentially a comfort feature–it alleviates chafing of the neck of drivers who are taller or shorter than a driver of average height.
If you need to remove your seat belt retractor or pre-tensioner out of your vehicle, this video will show you how to do that step by step. If your car has been in an accident or a crash, we can repair your seat belts!
How do you replace a bench seat belt?
2. Bucket Seat End (11″ curved hard sleeve) Insert the hex bolt through the hole in the (E) End of the bench seat belt end as shown in Fig. 3 , and then screw the hex bolt into the existing anchor point (threaded hole) and firmly tighten. Use a new hex bolt from Wesco or a 7/16″ fine thread hex bolt (Grade 5 or better) from the old seatbelt.
How do you replace a WESCO seat belt?
Step # 2: Replacement: Insert the hex bolt through the (A) Retractor End of your new Wesco replacement seat belt and then screw the hex bolt into the existing anchor point (threaded hole) located on the outboard side of the vehicle near the floor as shown in Fig. 1 and tighten.
How to install a 3 point seat belt?
Replacement Seat Belt 3 point formerly, #welr, FMVSS Federal Safety Approved Retractable Belt: CAUTION: Read these seatbelt instructions for 3 point retractable replacement seat belts thoroughly before installing this replacement safety harness.