How do you remove a passenger side vent?
Using a small screw driver or other similar device, gently pry the passenger side vents from the dash. Work the vent out evenly. If it is cocked to one side or the other it will tend to jamb. you can two or even four screwdrivers to do this quicker if you want. There is a phillips headed screw under each vent on the passenger side.
Why is my Blend door actuator not working?
It was a broken wire a few inches from the actuator, that was intermittently not connecting. It always worked when first used, but would fail after a few minutes. Straitening the wire made it work. https://rover.ebay.com/rover/1/711-53… When replacing, make sure to get the correct one for your trailblazer. Loading…
How to remove the passenger side temp control?
Pull the passenger handle from the dash. You can alternate from side to side until it is fully removed or you can have someone assist you. Grasp the upper edge of the trim panel and pull out. Once the upper edge is released, work the panel up until it releases from the dash panel.
Where is the actuator on the passenger side?
I thought I found it under the hush panel on the passenger side just in front of the center console, but it ended up being the driver’s side actuator. I can’t seem to find a thread that gives the location so any help would be awesome!
Is the passenger side blend door actuator changeable?
If you have not yet replaced it yet, or if there is anyone else who is about to, know that it is changeable without taking the whole dash apart like the writeup shows. I changed mine a few months ago by simply removing the glove compartment door, center vent cover and the small storage box under the center vent.
What do I need to replace car door actuator?
You will need a tool set including an 5.5 mm socket for Chevy, GMC, Cadillac, Ford and Lincoln vehicles. Using a small socket and ratchet remove the mounting bolts that hold the under dash plastic cover on the passenger side. These screws can be in obscure places so look around for them.
Where is the blend door actuator on my Tahoe?
I have the popular blend door actuator failure on a 2004 z71 tahoe with full auto HVAC. It is the passenger side that failed and I can’t seem to locate the actuator that does the temperature control for the passenger side vents.
Using a small screw driver or other similar device, gently pry the passenger side vents from the dash. Work the vent out evenly. If it is cocked to one side or the other it will tend to jamb. you can two or even four screwdrivers to do this quicker if you want. There is a phillips headed screw under each vent on the passenger side.
Pull the passenger handle from the dash. You can alternate from side to side until it is fully removed or you can have someone assist you. Grasp the upper edge of the trim panel and pull out. Once the upper edge is released, work the panel up until it releases from the dash panel.
How to remove the air vents on a Silverado pickup?
Place the screwdriver between the air vent and the dashboard and push it into the seam. Twist the screwdriver to pop the vent out the dashboard. The second vent on the passenger side of the dashboard comes out the same way.
Where is the actuator on the driver side?
1) the actuator is on the driver side to the right of the steering column. 2) before you touch anything, disconnect the negative battery cable and wait 10 minutes for the airbag capacitor to discharge. 3) remove the knee bolster (or “hush panel”) by putting your fingers in the curved part that is just below the steering column and pulling down.