How do you remove a bearing from a front wheel?
First, remove the bearing cap. This is a press fit, so to remove it, grab it with Channelocks and work the cap back and forth until it pops off. Be careful not to crush it in the removal process. Once the cap is removed you will see a cotter pin.
How to clean and repack wheel bearings and lug nuts?
Step 3: Remove the wheel from the hub. After the vehicle is raised, start on one side and complete the side before moving onto the other. The first step here is to remove the wheel from the hub. Use an impact wrench and socket or a star wrench to remove the lug nuts from the wheel.
Where are the wheel bearings on a car?
This is because the front rotors are often behind the front hubs, which means that to change the rotors you have to pull the hubs off the front spindles, at which point the bearings are practically in your hand. So, if you need to do a front brake job, check the wheel bearings.
What’s the best way to replace a front wheel?
Use a glob of grease to coat the inner bearing race, then set the inner bearing down inside it. Take the inner wheel-bearing seal and install it as you did the bearing races, tapping it into place and taking care not to cock it, but only get it flush with the inner surface of the hub. Don’t pound it in any farther than that.
What do I need to replace my front wheel bearing?
- Wheel bearing assembly
- Breaker bar
- Jack
- Socket set
- Ratchet
- Screwdriver
- Rubber mallet
- Sandpaper
How do you change wheel bearings?
To change wheel bearings, start by lifting the wheel up on a jack, unscrewing the lug nuts, and taking the wheel off. Then, remove the brake caliper, the dust cover over the rotor, and the cotter pin and castle nut behind the dust cover.
How do you install front wheel bearings?
Steps Park your vehicle on a flat surface. Use wheel chocks to secure wheels whose bearings you aren’t replacing. Loosen the lug nuts and lift the wheel using a jack. Unscrew the lug nuts and remove the wheel. Remove the brake caliper. Remove the dust cover, cotter pin, and castle nut. Remove the rotor. Unscrew the hub bolts and remove the old hub.
How do you press a wheel bearing?
1. Push Bearing into Bearing Case. 2. Place backing plate on press with the brake hardware side facing up. 3. slip in axle shaft with flange side (with the wheel studs) into backing plate so the flange side is pointing towards the top of the press with the spline end facing the ground.