How do you remove a battery from a Road King?
Removing the battery is straightforward, something you can do in a few minutes.
- Unscrew the bolt securing the passenger seat to the Road King’s rear fender, using a Phillips screwdriver.
- Unscrew the nuts from the back of the rider’s seat, using a 1/2-inch socket.
- Unscrew the battery clamp bolt, using a Torx driver.
How do you remove a battery from a Harley Davidson Road King?
Step 1 Unscrew the bolt securing the passenger seat to the Road King’s rear fender, using a Phillips screwdriver. Lift the passenger seat upward slightly, then pull it away from the rider’s seat. Unscrew the nuts from the back of the rider’s seat, using a 1/2-inch socket. Lift the rider’s seat upward slightly and pull it away from the gas tank.
How do you remove the gas tank from a road King?
Unscrew the bolt securing the passenger seat to the Road King’s rear fender, using a Phillips screwdriver. Lift the passenger seat upward slightly, then pull it away from the rider’s seat. Unscrew the nuts from the back of the rider’s seat, using a 1/2-inch socket. Lift the rider’s seat upward slightly and pull it away from the gas tank.
How do you remove the passenger seat from a road King?
Unscrew the bolt securing the passenger seat to the Road King’s rear fender, using a Phillips screwdriver. Lift the passenger seat upward slightly, then pull it away from the rider’s seat.
Step 1 Unscrew the bolt securing the passenger seat to the Road King’s rear fender, using a Phillips screwdriver. Lift the passenger seat upward slightly, then pull it away from the rider’s seat. Unscrew the nuts from the back of the rider’s seat, using a 1/2-inch socket. Lift the rider’s seat upward slightly and pull it away from the gas tank.
How do you change the battery on a Harley Davidson?
Open the lid of your saddlebag. Turn the thumb screws from inside the bag that mounts it to the frame. Lift the bag up off of the bike and carefully set it aside. Figure 1. Remove the saddlebag from one side of the bike. Use a 7/16″ socket or wrench to remove the bolt that holds the seat strap in place.
Do you have to remove the seat on a Harley?
You should begin every service, or repair with Harley Battery removal and Harley seat removal. The most important part would be disconnecting the battery negative cable.
Unscrew the bolt securing the passenger seat to the Road King’s rear fender, using a Phillips screwdriver. Lift the passenger seat upward slightly, then pull it away from the rider’s seat. Unscrew the nuts from the back of the rider’s seat, using a 1/2-inch socket. Lift the rider’s seat upward slightly and pull it away from the gas tank.