How do you read a Mitsubishi fault code?

How do you read a Mitsubishi fault code?

1. How to read OBD codes: Preparation.
2. Step 1: Plug the OBD scanner into the OBD port.
3. Step 2: Turn on the ignition.
4. Step 3: Enter the Vehicle Identification Number.
5. Step 4: Find OBD codes in the menu.
6. Step 5: Interpret the first character of the OBD code.
7. Step 6: Interpret the second character of the OBD code.

How do you open the endeavor hood?

How to Open the Hood on a Mitsubishi Endeavor

1. Locate the interior hood-release lever under the dashboard on the driver’s side of the interior of the car.
2. Lift up and toward you on the hood release lever.
3. Move to the front of the Endeavor and locate the exterior hood-release lever under the front of the hood.

How do you open the bonnet on a Mitsubishi Triton?

Bonnet

1. Pull the release lever towards you to unlock the bonnet.
2. Raise the bonnet while pressing the safety lock. NOTE. • Only open the bonnet when the wipers are in the parked position. In any other position, the wipers could damage the paint or bonnet.
3. Support the bonnet by inserting the support bar in its slot.

How does Mitsubishi Fuso diagnostic trouble code interpretation work?

Mitsubishi Fuso: Diagnostic Trouble Code Interpretation Control unit turns light off for 2.4 seconds after diagnosis and displays the code. The first digit of code illumination for 1.2 seconds and turns off for 1.2 seconds. The last digit of code will comes on for 0.4 seconds and turns off for 0.4 seconds.

How long does it take for Mitsubishi Fuso light to turn off?

The first digit of code illumination for 1.2 seconds and turns off for 1.2 seconds. The last digit of code will comes on for 0.4 seconds and turns off for 0.4 seconds. Light is turned off for 2.4 seconds between codes.

How to reconnect memory clear switch Mitsubishi Fuso?

Reconnect memory clear switch to erase DTCs. 3. Mitsubishi Fuso: Diagnostic Trouble Code Interpretation Control unit turns light off for 2.4 seconds after diagnosis and displays the code. The first digit of code illumination for 1.2 seconds and turns off for 1.2 seconds.

What are the trouble codes on a Mitsubishi?

Diagnostic trouble codes may be cleared by disconnecting the battery ground cable for at least 20 seconds. Reconnect negative battery cable and recheck codes to confirm the repair. Oxygen sensor fault. Airflow sensor fault. Intake air temp sensor fault. Throttle position sensor (TPS) fault. Idle speed control (ISC) motor position sensor fault.