How do you put transmission fluid in a Toyota Corolla?
Add New Transmission Fluid
- Find the type of transmission fluid you should buy written on the dipstick.
- Add the new automatic transmission fluid through the dipstick tube with the engine off.
- Replace the dipstick, start the engine and let it idle for a few minutes without pressing the gas pedal.
What kind of transmission fluid does a 2003 Toyota Corolla take?
The recommended transmission fluid for the 2003 Toyota Corolla is Dexron ViATF. The transmission fluid needs to be replaced every 30,000 to 60,000 miles.
How do you check the transmission fluid on a 2003 Toyota Corolla?
How to Check Automatic Transmission Fluids
- Pull out the dipstick. Put the car in Neutral or Park with the braking on, and keep the car running.
- Check the fluid. The transmission fluid on the dipstick should be bright red and almost clear.
- Wipe the dipstick with a clean rag, reinsert it, and pull it out again.
When should I change my transmission oil?
If you drive manual, most manufacturers will recommend changing your transmission fluid every 30,000 to 60,000 miles. If you have automatic, you can typically boost that range up to 60,000 to 100,000 miles. There’s no harm in changing your fluid early.
How do you fill the transmission fluid in a Toyota Corolla?
In order to fill the transmission fluid, we need to get a funnel that can enter in the fill port. I use a long transmission fluid funnel, and put a little extra piece of hose on the end to make the bend. Position the funnel (or tubing, if using that) so that it is into the fill port. Add fluid until it starts draining out. It should be about 2 qts.
Where is the oil drain on a Toyota Corolla?
Slide under the front driver side of the engine bay and locate the black metal transmission oil pan. The transmission oil drain bolt is located near the rear edge of the pan with the bolt head facing down towards the ground. Position the used oil catch basin to just below the drain bolt.
What kind of oil does a Toyota Corolla use?
3 quarts of Redline MT-90 API GL-4 gear oil, 75W-90. Suction Gun (For inserting gear oil into filler). (Left) Ratchet with 24mm shallow socket (deep won’t fit; space issue). (Right) Rubber Gloves. (Bottom Left) 10mm Hex/Allen Key. (Bottom Center) 2 Metal Crush Gaskets for drain and fill plugs.
How do you change the transmission on a Toyota Corolla?
1. Turn on the engine. 2. Engage the emergency / parking brake and firmly press down on the brake pedal. 3. Move the shifter knob to cycle the transmission through all the gears while pausing in each gear (e.g. “P” Park, “R” Reverse, “D” Drive) for a few seconds.