How do you measure boot opening?
First, grab a ruler or measuring tape. The boot shaft starts directly above the boot sole. You can run a measuring tape up the side of the boot from the top of the boot sole to the top of the shaft. This measurement is your boot shaft height.
What is ball girth?
– Ball girth measurement The circumference of the foot around the middle of the big and small toe joints. This joint is prominently visible on the inside of the foot just adjacent to the big toe.
How are the warning lights displayed on a Jaguar?
If a warning message is displayed along with a red warning light (highest priority), investigate the fault immediately. If more than one message is active, each is displayed in turn for two seconds in order of priority. Displayed when the brake fluid level is low. Depending on your location, warning light may be displayed in red letters BRAKE.
What is the diagnostic code for a Jaguar check engine light?
Refer to our Generic OBD II code list for definitions on all other Jaguar diagnostic trouble codes. Manufacturer Specific Codes P1000OBD Systems Readiness Test Not Complete P1104Mass Air Flow Sensor Circuit Ground – Read Our Article On Automotive Circuit TestingFor Help With This Jaguar Check Engine Light Code P1111System Pass
What to do if you get a message on your Jaguar dash?
The air suspension system is too low. Start the engine and wait for the message to clear before driving the vehicle. If the message is displayed while you are driving, restrict your speed until the message is cleared. If the message is persistently shown, inform your Jaguar Dealer. The driver’s and/or one or more passenger doors are open.
How does the seat belt light work on a Jaguar?
The seat belt sign will come on and a chime will sound if a passenger or driver unbuckles their belt while the car is in motion. The lamp will go out again when the relevant seat belt is buckled. (Note: if you put objects like bags or shopping on the front passenger seat, they may activate the seat belt reminder feature.
How to program remote fob for Jaguar XK8 XKR?
Auto Reserve Jaguar – XK8 XKR Remote Fob Programming – Detailed Instructions: The procedure to program the remote fob or fobs is very simple and should take less than one minute. No tools are required. All remote fobs available must be present when the car is in programming mode, so that they can be programmed at the same time as the new fob.
How to turn on headlight flasher on XK8 XKR?
Enter the car and sit in the Drivers seat. 2. Place the key in the ignition. 3. Hold the headlight flasher arm back – the blue “high beam” light will come on the dashboard and the headlights will come on. 4. Keep holding the headlight flasher back and turn the ignition key to position 1.
If a warning message is displayed along with a red warning light (highest priority), investigate the fault immediately. If more than one message is active, each is displayed in turn for two seconds in order of priority. Displayed when the brake fluid level is low. Depending on your location, warning light may be displayed in red letters BRAKE.
Where is the SLM on a XK8 XKR?
To find it, open the boot and remove the battery cover. There is a fuse box assembly next to the battery. Remove the 3 x 10mm bolts holding the fusebox carrier. The SLM is underneath the fusebox carrier. Q: I have programmed the fobs successfully, but when I press the button to lock the car nothing happens!