How do you install a soft top on a wrangler?
Install the bolts from underneath the sport bar. Same as with the front door surrounds, the rear door surrounds have notches that fit into the top of the sport bar. In addition there are a couple pegs on the bottom of the surround that fit into the belt rail of the Wrangler.
How to install rampage complete soft top with frame?
1. Locate Passenger Corner Belt Rail, (2) – 5/16” Torx Screws, (2) – 5/16” Flat Washers, and (2) – Tapping Plates. Position Corner Belt Rail onto vehicle and secure it by using hardware listed in this step. Repeat this step for opposite side. Note: There may be a slight gap between the Corner and Side Belt Rail. This is Normal. 1.
How big of a hole do I need to drill for soft top?
If holes are to big, you must replace the included screws with larger screws, found at any local hardware store. If you are replacing a hardtop, use the Windshield Channel as a template to drill 1/8” holes. WARNING: Ensure Windshield Channel is properly secured prior to installing the Soft Top.
1. Locate Passenger Corner Belt Rail, (2) – 5/16” Torx Screws, (2) – 5/16” Flat Washers, and (2) – Tapping Plates. Position Corner Belt Rail onto vehicle and secure it by using hardware listed in this step. Repeat this step for opposite side. Note: There may be a slight gap between the Corner and Side Belt Rail. This is Normal. 1.
How do you install a soft top on a car?
Insert the plastic Upright’s Pin through the Side Rail’s hole and lock it in place by sliding the square clip to the opposite side. NOTE: Make sure the Upper Side Rail is properly secure prior to installing the soft top. Damage to the vehicle or personal injury can occur if not installed properly. Repeat this step for opposite side.
Can you put a soft top on a jeep?
Using parts other than those provided in your Supertop kit can result in personal injury and/or damage to the vehicle and soft top. Improper windshield adjustment will result in poor fitting top and doors, causing looseness or undue strain on the top
Can you replace a soft top with a supertop?
If you are replacing an old soft top, be certain that all parts of the old top are removed, including the windshield retainer. Old metal parts are not compatible with the new Supertop. Using parts other than those provided in your Supertop kit can result in personal injury and/or damage to the vehicle and soft top.