How do you get grease out of grease nipples?
Try taking the zerk out, use a small wire and poke around. Might dislodge something. You could also put a drop or two of penetrating oil in before you install the zerk, and try seeing if that will go in, maybe loosening the clog.
Do you have to have grease fittings on your car?
Important: not all vehicles have grease fittings. In fact, as time moves forward the grease fitting is becoming a thing of the past. Sealed non-serviceable joints and front-end parts are now more common then ever before. But what if you have an older vehicle or even a newer one that still has chassis lubrication fittings.
Where did grease fittings go in the 80’s?
In the ’80’s and beyond cars eliminated the grease fittings that were mainly on the front suspension components. For a long time you took your car for a lube, oil, and filter (LOF).
Do you need lubrication for an oil change?
Chassis lubrication is something that should be done during an oil change, maintenance service or safety inspection. Important: not all vehicles have grease fittings. In fact, as time moves forward the grease fitting is becoming a thing of the past. Sealed non-serviceable joints and front-end parts are now more common then ever before.
When do you use grease as a lubricant?
Grease is a vital lubricant used in a host of applications, from electric motor bearings to open gears, wheel bearings to CV joints and even agricultural and construction industries.
What do you need to know about grease fittings?
This will prevent grains of sand or dirt to enter the grease fitting and hold open the check valve that will allow the grease to leak out. Carefully look at the joints and the boots that seal them. Common suspension parts that have grease fittings would be ball joints, tie rod ends, idler arms, and center links. Some fittings are hard to get at.
Do you need lubrication fittings for an oil change?
A vehicle’s frame is also known as its chassis. Few vehicles are still manufactured with chassis lubrication fittings, but if you drive an older vehicle there may be a host of grease fittings that need attention during your regularly scheduled oil change service.
Grease is a vital lubricant used in a host of applications, from electric motor bearings to open gears, wheel bearings to CV joints and even agricultural and construction industries.
How does a check valve on a grease fitting work?
Keep thin grease from leaking out— the check valve on these fittings has a Buna-N seat that creates a tighter seal than check valves on other grease fittings. Prevent damage to bearing seals caused by over- lubrication— these fittings automatically stop grease flow when pressure is within the shut-off range.