How do you fix a loose drywall anchor?
The easy repair is to replace it with a larger conical anchor, but that anchor will probably also pull out in time. A more effective solution is to replace it with a plastic screw-in anchor, a molly bolt or a toggle bolt. The last two types of anchors clamp against the back of the drywall for extra holding power.
Can a hammer be used to replace wheel studs?
The soft wood on the hammer won’t damage the threads, but will give you enough leverage to tighten the nut and pull the stud through the flange. With the studs removed, we again rotated the axle to allow room to insert the longer studs, and then we used a group of washers and a nut to pull the stud into place.
Can you replace the rear wheel studs on a Plymouth?
We replaced the rear studs on our ’65 Plymouth, but the front studs can be replaced in a similar manner. After putting the car on jack stands and removing the wheels, the task of replacing the studs is much easier than you think. You don’t need to press them out, you simply use a hammer or a five-pound sledge like we did to pound them out.
What should I do if my wheel stud is broken?
Above all, don’t hammer out the broken stud. That’s the worst thing you can do! The hammer blows can wreck your wheel bearings and turn this into a much bigger repair bill. Instead, squeeze the broken stud out with the remover tool.
What’s the easiest way to replace a stud?
However, if you feel you don’t want to employ this method, you can remove the axle nut, slide hammer the hub out of the bearing, replace the stud on the bench, press the hub back into the bearing, and hope your bearing doesn’t go bad as a result of separating it. Either way works.
The soft wood on the hammer won’t damage the threads, but will give you enough leverage to tighten the nut and pull the stud through the flange. With the studs removed, we again rotated the axle to allow room to insert the longer studs, and then we used a group of washers and a nut to pull the stud into place.
How do you replace a wheel hub stud?
Turn the wheel hub back over so that the wheel stud threads are facing up. Punch the studs out with a hammer and a brass drift. Use a lint-free cloth to clean up the threads inside the wheel hub mounting holes. Note: It is recommended to replace all of the wheel studs on the wheel hub that has a broken stud.
However, if you feel you don’t want to employ this method, you can remove the axle nut, slide hammer the hub out of the bearing, replace the stud on the bench, press the hub back into the bearing, and hope your bearing doesn’t go bad as a result of separating it. Either way works.
Can a wrench be used to replace a wheel stud?
A few good turns of the wrench, as if you’re tightening them down on the wheel, and you’ll be able to feel when it has completely seated. You won’t need to put all of your weight on it, just enough to pull the stud through.