How do you do a proper drive cycle?
15 minutes of steady driving on an expressway/highway followed by 20 minutes of stop-and-go driving with at least four 30-second idle periods. Allow the vehicle to sit for at least eight hours without starting the engine. Then, start the engine and complete the above driving cycle.
What is FTP drive cycle?
The EPA Federal Test Procedure, commonly known as FTP-75 for the city driving cycle, are a series of tests defined by the US Environmental Protection Agency (EPA) to measure tailpipe emissions and fuel economy of passenger cars (excluding light trucks and heavy-duty vehicles).
What was the drive cycle for incomplete readiness?
He then turned off his vehicle and restarted the vehicle the next morning and allowed it to idle for another 5-10 minutes. He stated that this procedure completed the AIR readiness monitor.
How is the driving cycle performed in a car?
In commercial vehicles area, the driving cycle is not performed on a vehicle dynamometer but on an engine dynamometer and is evaluated through a set of engine torque and speed points instead of vehicle speed points.
What do you need to know about the Mercedes Drive Cycle?
If using a Hand-Held Scan Tool verify Step 1 test completion. This will be indicated by a check mark in the display field or the word PASS. 2. Lambda (02) Sensor Signal (do not interrupt this portion of the test, to be conducted directly after • Drive vehicle for 3 minutes at 70km/h (43 mph).
Which is the correct way to get on a motorcycle?
The lever on the right side of the bike near your foot works the rear brake. As a rule, the left side of your motorcycle controls gears, while the right side controls acceleration and braking. Get on the bike. To properly get on your bike, face the motorcycle from the left side. Grab the left handlebar, and swing your right leg over the seat.