How do you clear the code on a Toyota Rav4?
When performing maintenance yourself, you’ll need to manually reset the maintenance lights.
- Insert the key into the ignition.
- Press and hold the trip meter reset button. Turn the engine switch to the “on” position. Hold the trip meter reset button until the trip meter displays “000000.” The maintenance light is reset.
How do I reset my Toyota rav4?
Turn the Rav4 off and take the key out of the ignition. Reinsert key but shift to the “acc” or “on” position and then “off” again. Repeat this cycle 3 times witH3 second intervals in between each step. At the end of the third cycle, turn the engine on once again.
How do I remove battery clear code?
How to Disconnect a Car Battery to Reset the Computer
- Clean any corrosion off of the battery and terminals with a can of spray-on battery cleaner.
- Hold the positive and negative cable ends together so they’re touching each other but not the battery.
- Wait five minutes for the diagnostic information to be erased.
What are the diagnostic codes on a Toyota RAV4?
Dtcs c1273/73, c1274/74, c1277/77 and c1278/78 are output only in the test mode. Dtc c0210/33 and c1238/38 relate to the skid control sensor rh. Dtc c0215/34 and c1239/39 relate to the skid control sensor lh.
What to do if your Toyota RAV4 has a problem?
Remove the skid control sensor (for 2wd) or rear speed sensor (for 4wd). Check the sensor tip. Ok: no scratches or foreign matter on the sensor tip. Disconnect the a19 ecu connector. Disconnect w1 and v1 sensor connectors for 2wd. Disconnect k23 and k22 sensor connectors for 4wd.
When to delete DTC c0200 / 31 in RAV4?
Refer to dtc c0200/31 (see page bc-62). Dtcs c1273/73, c1274/74, c1277/77 and c1278/78 can be deleted when the speed sensor sends a vehicle speed signal or the test mode ends. Dtcs c1273/73, c1274/74, c1277/77 and c1278/78 are output only in the test mode. Hint: Dtc c0210/33 and c1238/38 relate to the skid control sensor rh.
How do you reset the ignition on a Toyota RAV4?
Press And Hold ODO TRIP BUTTON/DISP BUTTON And Turn Ignition To The “RUN” Position. Hold ODO TRIP BUTTON/DISP BUTTON For At Least 5 Seconds Until “MAINT REQD” Flashes Multiple Times And The Light Goes Off. Turn The Ignition OFF. Maintenance Reset Is Complete. Turn the ignition on. don’t start the engine (Accessory mode)