How do you check the oil on a Yamaha Grizzly 600?
After running the engine, shut it off and let it cool 5 minutes. The level should be between the low and high marks in the window. The window will be located by the footpeg to the rear and below of the flywheel cover. The motor takes just over 2L of oil with an oil change.
How much oil does a Yamaha Grizzly 660 take?
Fill the engine with 2.11 quarts of 10W40 ATV engine oil, and reinstall the dipstick.
How much oil does a Yamaha 600 Grizzly take?
Doug E. : The motor takes just over 2L of oil with an oil change. Doug E. : If rebuilding the motor and draining the oil cooler, it will take 2.7L Doug E. : On an oil change, I put in 2L, run it, let it cool, then top it off. Doug E. : Having 3 Quarts of oil on hand for an oil change will cover it. Doug E. : Do you have the owner’s manual?
How do you change oil on a Grizzly 660?
Step 1. Run the engine for about half a minute to warm the oil, which makes it less viscous and helps it drain faster. Remove the dipstick so the crankcase can vent, which also helps the oil drain out faster. Step 2. Position a drain pan beneath the engine, and remove the 17mm oil drain bolt and crush washer.
Are there any issues with Yamaha 16 Grizzly engines?
Apparently, there are some owners having smoking and oil consumption issues with their 16’s. Apparently they had a bad batch of valve guides. The engines are all made by Subaru for Yamaha. I hear that Yamaha is aware of the issue and has been paying for the repairs when owners are taking them to task.
What kind of oil to put in a grizzly?
If you have used regular oil, you have to clean the clutch. Best way to do that is mix some ATV oil 50/50 with kerosene. Dump it in, run it for like 2 minutes. Then drain the oil, put on a new filter (you could clean the old filter but its better to use a new one), and put in new oil. Then run it for like 10 minutes.
What kind of oil do you put in a Grizzly 600?
Add the replacement oil through the oil filler port, using a funnel. The Grizzly 600’s capacity is 2.1-quarts. If you ride in temperatures from below zero to 30 degrees F, Yamaha recommends 5W-30 oil; from 10 degrees F through 100 degrees F, Yamaha recommends 10W-30; from 40 degrees F through 120 degrees F, Yamaha says to use 20W-40 oil.
How do you change oil on a Yamaha Grizzly?
The type of engine oil recommended by Yamaha varies. Park your Grizzly on level ground. Gather the tools needed to change the oil. Remove the three Phillips screws from the left side engine cover. Pull this cover off. Start the engine and let it run for about five minutes (to warm up), then turn it off.
Where is the oil drain plug on a grizzly?
Place your oil drain pan underneath the Grizzly. Twist off the oil filler cap — it’s also the dipstick — and set it aside in a safe place. Remove the oil drain plug with a socket wrench; it’s located on the underside of the Grizzly.
How much oil does a Yamalube 4 10W30 take?
Looks like per the manual it should take 2.1 quarts w/oil filter cahnge. With out oll fiter change and just the oil 2.0 quarts. The manual suggests Yamalube 4 10w30 or 20w40. Hope this helps. Did you find the recommended reading relevant to this discussion?