How do you change a manual lock to a power lock?
Plug in all harness connections and wire the Central Locking Module to a constant-hot circuit per the instructions. Then test the system. All locks should spring into action when one is activated either manually or with a key. For out-of-sync locks, unplug and reverse the wiring harness at the actuator.
What do I need to make a power lock?
The basic kit includes Swiss-made actuators (in 2- and 4-door configurations), the Central Locking Module, a wiring harness, mounting hardware and instructions. Options include a keyless remote system that has two 4-button transmitters with a 100-foot range; the base kit also integrates with most alarms or keyless entry systems.
Is there a universal power door lock kit?
Electric-Life’s Universal Power Door Lock Kit includes an actuator for each door (2-door kits available), the central locking module/relay, wiring harness, lock rods and mounting hardware. Keyless-remote is an optional upgrade. Carefully remove the door handles and window cranks (which might require a special tool).
What should I do if my door lock goes out?
Use cables that are wider than 0.2 mm. Thinner cables are not sufficient to carry power all the way from the power source to the door lock. Measure the voltage at the lock point when the lock is in operation mode. Apply battery backup power supply to individual door locks to solve power outages and enable 24/7 electricity supply.
Plug in all harness connections and wire the Central Locking Module to a constant-hot circuit per the instructions. Then test the system. All locks should spring into action when one is activated either manually or with a key. For out-of-sync locks, unplug and reverse the wiring harness at the actuator.
How to wire a door to a power lock?
Route the wiring harness under carpet and through the door jambs to each actuator: 5-wire connections to front actuators, 2-wire ones to the rear. If the harness can’t be fished through existing door-jamb conduit, Electric-Life offers several drill-and-mount options that’ll keep the wires from getting pinch when the doors are shut.
Electric-Life’s Universal Power Door Lock Kit includes an actuator for each door (2-door kits available), the central locking module/relay, wiring harness, lock rods and mounting hardware. Keyless-remote is an optional upgrade. Carefully remove the door handles and window cranks (which might require a special tool).
How does a power door lock work on a Jeep Wrangler?
The pre-formed linkage rod is attached to the latch and the latch is bolted back into the door. The door lock actuator is bolted into the door. The keyless entry module goes under the left side of the dash and the wiring harness is run under the dash and into doors. A high quality quick disconnect is provided for each door.
Can a car be bought without a power door lock?
These days, buying a new vehicle that isn’t already equipped with power door locks and windows can be a challenge. Power accessories are usually bundled in an option package, and most car dealers stock surprisingly few “stripper” models on their lots.
What can I use to plug in a power lock?
If the harness can’t be fished through existing door-jamb conduit, Electric-Life offers several drill-and-mount options that’ll keep the wires from getting pinch when the doors are shut. We used existing front conduit and cut holes in B-pillar drain plugs.