How do you change a belt on a Honda Civic?
How to Change the Serpentine Belts on a Honda Civic
- Locate the belt tension bolt in your Honda Civic’s engine bay.
- Place the belt tensioner on the bolt inside the engine bay then turn it counterclockwise to loosen the belt.
- Pull the old belt off of the engine pulleys manually then discard it.
When to replace timing belt in 1991 Honda Civic?
How to Replace a Timing Belt in a 1991 Honda Civic. Honda recommends replacing the timing belt at 60,000-mile intervals on the Civic.
How do you tighten the belt on a Honda Civic?
Tighten the belt tension bolt by turning it clockwise with the belt tensioner tool. Refer to the owner’s manual for your year Honda Civic for the exact pound feet of torque that your Civic’s belt needs to be tightened to. Whenever working on a car’s engine, make sure you have given it adequate time to cool.
How do you replace a belt on a Honda Accord?
Be sure that when replacing the old belt with a new one, you follow the same pulley sequence, which should be shown on a sticker under the hood or in your maintenance manual. If you purchased an OEM replacement belt or any other belt for that matter, the reverse side of the package may also have the diagram.
Where is the tension bolt on a Honda Civic?
Locate the belt tension bolt in your Honda Civic’s engine bay. This can be found on the bottom left of the alternator, right next to a section of the belt.
How to Replace a Timing Belt in a 1991 Honda Civic. Honda recommends replacing the timing belt at 60,000-mile intervals on the Civic.
How do you install a new timing belt?
Loosen the tensioner with a wrench, push it away from the belt and tighten the tensioner bolt just enough to hold it in place. Remove the timing belt. Install the new belt clockwise, starting at the crankshaft pulley, moving to the camshaft pulley, over the water pump and then the belt tensioner.
Where is the timing tab on a Honda Civic?
Turn the crankshaft counterclockwise and line the mark on the crankshaft pulley with the tab on the timing cover. The tab is in the center of the cover just above the crankshaft pulley. To make sure that the number one cylinder is on top dead center, check the alignment marks on the camshaft pulley.