How do you break in a new Jeep?
Drive moderately during the first 300 miles. After the initial 60 miles speeds up to 50 or 55 mph are desirable. While cruising, brief full-throttle acceleration contributes to a good break-in. Wide-open throttle acceleration in low gear can be detrimental and should be avoided.
What is the factory manual for a Jeep Cherokee?
It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time. This manual for 2014, 2015, 2016 Jeep KL Cherokee Latitude, Cherokee Limited, Cherokee Sport, Cherokee Trailhawk is divided into different sections.
When to replace motor mounts on Jeep Wranglers?
While the instructions are specific to the installation on a 1992 Jeep Cherokee, the installation procedures related directly to the motor mounts are virtually identical on all 1987-2006 Jeep Wranglers and Cherokees with the 4.0L engine.
How do you remove a motor mount on a Jeep Cherokee?
Starting with the drivers side motor mount, use the 18mm socket to remove the nut from the main motor mount bolt. Using the 15mm socket, loosen but do not remove the bolt and nut that hold the motor mount to the body / frame of the Jeep. A universal joint socket adapter will make this part easier, as clearance is somewhat limited.
What’s the difference between a Jeep Laredo X and a Grand Cherokee?
In terms of specification, there isn’t a big difference between this and the Laredo X. It adds Capri leather to the front seats, a single pane sunroof, and heated side mirrors. You can add more optional packages, however.
It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time. This manual for 2014, 2015, 2016 Jeep KL Cherokee Latitude, Cherokee Limited, Cherokee Sport, Cherokee Trailhawk is divided into different sections.
How often do you change the cabin filter in a Jeep Cherokee?
The cabin air filter in your 2014 Jeep Cherokee filters the air that is blown from your heater or air conditioner into the cabin of your Cherokee. You need to change it at least once a year or every 20,000 miles.
What does ECU stand for in Jeep Cherokee?
Jeep ECU – Electronic Control Unit Reset. The Electronic Control Module, or ECU as it is most commonly called, is a generic term used for any embedded system within a vehicle that controls one or more electric system(s) or subsystem(s). The following sequence is used to reset the ECM or PCM as it is sometimes refered too.
How do you reset the ECM on a jeep?
The following sequence is used to reset the ECM or PCM as it is sometimes refered too. 1. Disconnect the battery by removing the Negative battery cable (This will ensure that any possibility of grounding the power side to the vehicle [or yourself – think wedding ring] does not happen.) 2. Disconnect the Positive battery cable 3.