How do you bleed a clutch slave cylinder?
Open the bleeder valve – Use a line wrench to open the bleeder valve to the slave cylinder. Place a drain pan under the slave cylinder to catch the brake fluid. Bleed the brake fluid – Leave the bleeder open and allow gravity to bleed the slave cylinder for one to three minutes.
How do you bleed a clutch slave cylinder without a bleeder screw?
The proper bleeding procedures for slave cylinders without bleed screws is as follows:
- Push the slave cylinder pushrod inward and disconnect both bands of the retaining strap to enable the pushrod to fully extend.
- Tilt the slave cylinder to a 45° angle.
- Insert the master cylinder line into the slave cylinder port.
How to bleed the clutch on a master cylinder?
Bleeding Your Clutch Check the fluid level in the master cylinder. Locate the bleed screw on the slave cylinder. Attach the hose to the bleed screw. Open the bleed screw on the slave cylinder. Have a friend press the clutch pedal in and hold it. Close the bleed screw. Have your friend release the clutch pedal.
How do you bleed air from a slave cylinder?
Adding the new parts introduces air into the system, which creates a soft or non-existent clutch action when you press the pedal. To bleed air from the hydraulic clutch system, you must release air from the slave cylinder.
Where do I find the bleed screw on my car?
You will find the bleed screw on the bottom or the underside of the slave cylinder. It looks like a bolt with a nozzle sticking out of it. If you have difficulty locating the slave cylinder or bleed screw, refer to the service manual for your vehicle.
What happens when you close the bleed screw?
This will once again seal the hydraulic clutch system, preventing air from getting sucked back into the system through the bleed screw. If your friend releases the pedal before you close the bleed screw, air will be sucked into the system, making the bleeding process significantly longer.