How do you adjust the wheel bearings on a car?
The bearing is adjusted by tightening the hub nut if it is too loose, or loosening the nut if it is too tight. It should be done with the wheel on and raised on an axle stand. Check for bearing wear. Rock the wheel from side-to-side and top-to-bottom to check for bearing wear.
What kind of wrench do I need to change wheel bearings on a VW?
Some VWs have the fourth type: a threaded collar which is squeezed tight by a nut and bolt at one side. The collar does not fit an ordinary socket wrench, but can be turned by a self-locking wrench. The hub nut may be castellated and retained by a split pin.
Where can I buy Hyundai Excel spares online?
VE Online stock a large range of Hyundai Excel parts including aftermarket parts and spares.
What should I do if my wheel bearings are disintegrating?
If there are traces of metal in the bearing, it is disintegrating and should be renewed at once (See Removing wheel bearings ). If the grease looks clean, wipe it away with a rag. Straighten the split pin and pull it out with pliers. Discard the pin and fit a new one later. Remove any castellated retainer.
Is it necessary to replace wheel bearings on a Hyundai?
When it comes to the nuts and bolts of bearing replacement, Hyundais offer no special challenges and an experienced tech should have no problem handling the job. As always, it never hurts to go over the basics. We’ll take a look at the recommended procedure as outlined on the Hyundai service information website, www.hmaservice.com.
When to remove the hub from a wheel bearing?
It’s easier to clean up the threads on a tie rod end before it’s removed from its taper, than it is later; a couple of extra minutes during disassembly can pay dividends on the other end. With the bearing carrier on the bench, the first step is to remove the hub from the bearing.
Do you press on the outboard wheel bearing?
We are warned not to press on the outboard inner bearing — that doesn’t change — the race has to be supported as the hub is installed; this is where the hub tools excel in the adapters provided. We find it easiest to have the hub on the press table and press the bearing carrier onto the hub, making sure the races are fully seated.
Why does my Hyundai make a noise when I turn a corner?
Make note of the sound as the load changes around corners; it will give you an idea of which bearing has failed (the noise will usually increase with load). If there is no change, it’s an indication there may be another problem disguising itself as a bearing.