How do I reset the EPB on my Jaguar XF?
If the battery has been discharged or disconnected, Apply Foot And Park Brake will be displayed in the Message centre when the ignition is next switched on. Press the brake pedal and pull the EPB switch up to apply the EPB. This is required to reset the EPB system. The EPB will now function correctly.
How to reset e brake module on Jaguar S-type?
Your problem may be due to low battery voltage, faulty park brake motor, module or possibly broken or binding parking brake cables. What you can do is reset the system. DIsconnect the negative battery cable for 10 minutes. Then reconnect it and start the engine. It will say “Apply park brake” on the messgae center.
Is the hand brake jammed on a Jaguar?
I visited the Jaguar forum before I bought my S type Sport (2004). I noted all the problems that people had and still bought one. yes You guessed it; THE HAND BRAKE IS JAMMED ON. Even though this eemed to be a problem at the time I have left the car in my garage for 2 months whilst away. The car started first time and I was so pleased.
How do you change the parking brake on a Jaguar?
To recalibrate it disconnect your battery and leave for 10 Min’s. then reconnect and with the ignition on apply the foot brake and whilst keeping applied switch the parking brake on. then release the foot brake turn ignition off – on and the handbrake fault message should be gone and the parking brake should release as you drive off.
How to calibrate a jagrepair EPB motor?
To do this, set the system into ‘Calibration Mode’ by doing a battery reset. Then, with ignition ‘ON’ and the vehicle brakes at room temperature, lightly press the brake pedal and apply the parking brake. Date of issue 12/05 Bulletin Number XJ206-07 Page 3 of 10 DTC C1784 – EPB MOTOR OUTPUT SHORT TO GROUND.
What does the electronic park brake do on a Jaguar?
The Electronic Park Brake (EPB) is an electrically operated parking brake system, consisting of the EPB switch, control module, actuators (a rear brake control motor) and two warning indicators. Loading…
What do you do when you hit Your handbrake on a Jaguar?
This indicates that the parking brake is in calibration mode. 5. Lightly press the foot brake pedal. 6. Apply the parking brake by using the EPB switch. 7. Release the parking brake. 8. Release the foot brake.
Your problem may be due to low battery voltage, faulty park brake motor, module or possibly broken or binding parking brake cables. What you can do is reset the system. DIsconnect the negative battery cable for 10 minutes. Then reconnect it and start the engine. It will say “Apply park brake” on the messgae center.
When to apply foot and park brake on a Jaguar?
If a fault in the system is detected, Park Brake Fault or Cannot Apply Park Brake will be displayed in the Message centre. Seek qualified assistance as soon as possible. If the battery has been discharged or disconnected, Apply Foot And Park Brake will be displayed in the Message centre when the ignition is next switched on.