How do I reset my Hyundai HomeLink?

How do I reset my Hyundai HomeLink?

Inside your Hyundai vehicle, press and hold the garage door button on your garage door remote control, while simultaneously pressing and holding the HomeLink® garage door button on your Hyundai rear view mirror. Continue to press and hold until the red light on your rearview mirror turns solid, or flashes very quickly.

How to program keyless entry remote in a Hyundai Sonata?

Insert the key into the ignition of your Sonata and turn the key to the “On” position. Depress and hold the “Lock” button on your remote for one full minute. This allows the remote and the control module to communicate and sync.

Where is the alarm control module on a Hyundai Sonata?

While they will program it for you, you can do it yourself and save a programming fee. Locate the fuse panel under the dash on the driver’s side of the car. Just below it is the control module for the factory alarm system. Open the cover on the alarm system control module and locate the memory switch inside.

Where is the memory switch on a Hyundai Sonata?

Locate the fuse panel under the dash on the driver’s side of the car. Just below it is the control module for the factory alarm system. Open the cover on the alarm system control module and locate the memory switch inside.

How to learn the throttle in a Hyundai?

The battery must read above 10-volts and engine temperature must be above 41.5 degrees for learning to complete successfully. 1) Turn the ignition key ON for at least 10 seconds and then OFF for at least 10 seconds. This procedure allows the ECM to automatically learn the throttle valve position.

What should I do if my Hyundai Sonata emission monitor is not ready?

If all other emissions systems are functioning properly, completing the drive cycle above should set or make ready (complete) your Hyundai Sonata’s emission monitors. If the emission monitors are still not complete then check for any trouble codes and whether the check engine light is on or not.

How long does it take to idle a Hyundai Sonata?

• Idle engine then idle in Drive for 1 to 2 minutes. • Accelerate within 15 seconds to 50-55 mph (using 1/4 to 3/4 throttle) and keep this speed steady for 10 to 20 minutes.

How can I Fix my Hyundai Sonata smog test?

The fix requires driving your Hyundai Sonata through a drive cycle. A drive cycle is a series of driving patterns which allow your vehicle’e engine control unit to perform various emission tests, referred to as Emission Monitors. In order for your Sonata to pass the smog check these monitors must show Ready or Complete.

What does a drive cycle on a Hyundai Sonata do?

A drive cycle is a series of driving patterns which allow your vehicle’e engine control unit to perform various emission tests, referred to as Emission Monitors. In order for your Sonata to pass the smog check these monitors must show Ready or Complete. The following is a description of the Hyundai Sonata Drive Cycle.