How do I reset my HP 4700 fuser?

How do I reset my HP 4700 fuser?

Basically all you must do is install a replacement fuser from us, then turn on your printer, and the power-on process will automatically reset the page count for you. To ensure this process works correctly, double-check that your printer’s power is off before you install the new fuser.

How can you tell if a fuser is bad?

Streaking, smudging, black lines, and double images are all symptoms of a bad fuser. When you notice these printing defects and experience problems, such as paper jams or wrinkles, this is a good sign to replace the fuser kit.

What is a fuser kit for HP printer?

The fuser unit is a very important component of laser printers. The fuser unit, which is essentially two heated rollers, uses pressure and heat to fuse the toner powder onto the paper. Depending on your printer model, the fuser unit may be sold separately or it may be included in the printer’s maintenance kit.

How do I reset my HP 4700?

To Perform a Cold Reset via Control Panel:

1. Turn the printer off…
2. Turn the printer on.
3. When you see the memory count begin, Press and hold the √ key.
4. When all three LED lights remain lit, release the √ key.
5. If a bootloader password has been set, a prompt to enter the password will be displayed in the control panel.

What is the lifespan of a laser printer?

The printer’s lifetime depends on the model, level of use and operating conditions. Most desktop laser printers have an expected lifetime of about five years. In most cases, a laser printer allows for replacement of major components when they wear out, so you can keep the unit going long after its warranty expires.

How do I install a fuser in my HP printer?

HP LaserJet 4000 fuser installation instructions

1. Turn the printer off and unplug the power cord.
2. Next, lower the rear output bin cover as shown below.
3. Loosen the two fuser assembly screws shown below, pull the fuser straight out.
4. Install the replacement fuser by inserting it and aligning the left side first.

How do you reset a transfer belt?

Reset the Transfer Belt Life / Counter

1. Login as the Administrator at the Control Panel. See the Related Content for Additional Information.
2. Select the Machine Status button.
3. Select the Tools tab.
4. Select Troubleshooting.
5. Select Resets.
6. Select Supply Counter Reset.
7. Select Transfer Belt.
8. Select Reset Counter.