How do I put oil in my AC compressor?
Pour the oil very slowly into the intake port or low side of the compressor. This is where the large line entered. While pouring in the refrigerant oil, rotate the hub and clutch slowly to let the oil enter the compressor.
How do you put oil in AC compressor?
Add the right type and amount of oil and secure the rear cap. Hold the compressor so that the open end is facing upward. Insert a funnel that fits into the opening and slowly pour the recommended amount and type of oil. Then, screw the rear cap on tightly and use a wrench to tighten it further so it’s secure.
How to add Freon to a 2000 Jeep Cherokee?
How to add freon to your 2000 Jeep Cherokee: hook up the can of refrigerant (likely r-134a) to the low pressure port. When your compressor kicks on, add freon to the correct pressure. In addition to cooling, freon lubricates the compressor when it runs. Advance Auto coupon for 20% off entire order: KIOSK20
How do you empty an air conditioner compressor?
Empty the air conditioning compressor of all the oil by holding the open end down while rotating the clutch by hand in the normal direction of rotation. Retrieve the correct amount of oil information from the AC sticker on the car or from a maintenance manual.
How to drain and add refrigerant oil?
http://www.buyautoparts.com/ac-compre… AC compressor refrigerant oil capacity is usually stamped on the compressor. After you add oil to the ac compressor you should cycle the ac compressor by rotating the clutch plate three to four times. Remember to check the compressor to see how much refrigerant oil is recommended.
Add the right type and amount of oil and secure the rear cap. Hold the compressor so that the open end is facing upward. Insert a funnel that fits into the opening and slowly pour the recommended amount and type of oil. Then, screw the rear cap on tightly and use a wrench to tighten it further so it’s secure.
Empty the air conditioning compressor of all the oil by holding the open end down while rotating the clutch by hand in the normal direction of rotation. Retrieve the correct amount of oil information from the AC sticker on the car or from a maintenance manual.
http://www.buyautoparts.com/ac-compre… AC compressor refrigerant oil capacity is usually stamped on the compressor. After you add oil to the ac compressor you should cycle the ac compressor by rotating the clutch plate three to four times. Remember to check the compressor to see how much refrigerant oil is recommended.
What happens if you put the wrong oil in an A / C compressor?
If the wrong type of compressor oil or the wrong viscosity compressor oil is used, it may damage the compressor. In fact, the main reason for a newly installed A/C compressor to fail is using the wrong type of compressor oil.