How do I program my Pontiac G6 key fob with remote start?
Press and hold the “Lock” and “Unlock” buttons on your remote for up to 30 seconds, until you hear another chime. This will indicate successful programming and you can remove the key from your ignition.
How do you program a 2006 Pontiac remote?
Press down and hold the “Unlock” and the “Lock” buttons at the same time. Continue to hold them for 14 total seconds, during which you will hear two chimes; one at seven seconds and one at 14 seconds. These two chimes indicate that the remote is synchronized and programmed, respectively.
How do you remote start a 2006 Pontiac G6?
a Remote Start Press and hold the (Remote Start) button until the parking lamps turn off. Press and release the Hazard Warning Flashers button inside the vehicle. Press the button again to turn off the flashers. Turn the key in the ignition switch to the Run ( ) position and then to the Off ( ) position.
How do you program a 2007 Pontiac remote?
PRESS and HOLD the Trip Odometer Reset Button for 3 seconds until “REMOTE KEY LEARNING ACTIVE” displays. Vehicle is now in Programming Mode. PRESS and HOLD LOCK and UNLOCK buttons at the same time on the first remote for 15 seconds. The vehicle will emit a sound indicating successful programming of the remote.
How do you program a key fob for a 2007 Pontiac G6?
INSERT working Transponder Key into Ignition and TURN to the ‘ON’ position (just prior to cranking engine), WAIT 1 second and TURN back to the OFF position to successfully enter Programming Mode. REMOVE key from Ignition. INSERT NEW key into Ignition and TURN to the ‘ON’ position (just prior to cranking engine).
Does my Pontiac G6 have keyless entry?
Introduced in 2005, the Pontiac G6 became one of Pontiac’s top-selling cars. The car often comes standard with a keyless-entry remote program, and the program allows remote access to the doors, trunk, panic button and car starter.