How do I program my ignition key?

How do I program my ignition key?

Programming a Single Key

1. Insert the key into the ignition, and turn it to the on position.
2. Leave the key in this position for 10 minutes and 30 seconds, and then turn it off.
3. Turn the key back on, and wait for additional 10 minutes and 30 seconds before turning it off again.
4. Repeat the process for a third time.

How do you program a 2006 rav4 key?

Programming Instructions:

1. Begin with the key out of the ignition.
2. OPEN and UNLOCK the DRIVER’S side door.
3. Within 5 seconds INSERT the key into the ignition and PULL it out TWICE.
4. CLOSE then OPEN the DRIVER’s side door TWICE.
5. Insert key INTO the ignition then REMOVE it.
6. CLOSE then OPEN the DRIVER’s side door TWICE.

How do I program my original transponder key?

How to Reprogram a Transponder Key

1. Enter your vehicle and put the key into the ignition and turn it to the “ON” position. Leave it in for 10 minutes and 30 seconds.
2. Before 45 seconds pass, turn the key to the “OFF” position.
3. Repeat the above step by turning the key to the “OFF” position within 45 seconds.

Can I program a car key with only one key?

Close all doors, then open drivers door and press the Unlock button on driver’s door while it is open, insert key into ignition. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.) 3. Within 10 seconds press any button on the first keyless remote to be programmed.

How long do you leave ignition key on while programming?

Connect a battery charger to the battery to ensure power is available while programming. Both the BCM and PCM must be working and communicating with each other. Insert ignition key and turn to the “ON” position. Do not attempt to start the engine. Leave the key in the “ON” position for approximately 11 minutes.

How do you program a new Ford key?

Once you have a replacement key, the steps you need to take to get it fully programmed are very simple and easy to understand. 1. First you need to open the door and put the vehicle key in the ignition. 2. Next you need to turn the key clockwise from the “off” position to the “on” position.

How long does it take to relearn the ignition switch?

When performing this relearn, all previously learned keys will be erased. Additional keys may be relearned immediately after the first key has been learned by inserting the additional key and turning the ignition switch to on within 10 seconds of removing the previously learned key. Turn key to the “ON” position without starting the engine.

How do you start a car with a key fob?

Turn the ignition on. Sit in the driver’s seat with the ignition key and the key fob (also called a keyless entry remote). Close all doors. Place the key in the ignition and turn it to the on position. Don’t start the engine.