How do I know if my battery tender jr is working?
With the tender connected, and in a charge mode (check its lights to see what it is doing), the battery’s voltage should increase to above 13 Volts, over a period of 5-10 minutes, as this indicates it is being charged by the tender, similar to what the alternator does in the bike, running down the road.
How long does a battery tender take to charge?
A completely dead battery should take at least 35-45 hours or more with a Battery Tender Junior (0.75 amps), and 20-30 with a Battery Tender Plus (1.25 amps). Unfortunately, these chargers cannot begin to charge a fully depleted battery. They need to sense a certain amount of voltage before they can function.
When does battery tender plus go into storage mode?
If the battery voltage does not reach 14.5 volts within 72 hours, then the Battery Tender plus will also go into storage mode. Red light keeps flashing. Green light turns on quickly at the beginning of the charge cycle.
How to know if my Battery Tender is fully charged?
1 Battery is already fully charged. Disconnect the charger from the battery and check the battery voltage with a voltmeter. It battery voltage is at least 12.7 Volts, then it is fully charged. 2 Poor electrical contact. See notes on cleaning electrical contacts. 3 Battery may be defective.
Why do you need a battery tender in your car?
Battery tenders are your ultimate saviors specially in winters when headlights, wipers, and heater are running most of the time. These tenders not only provide continuous voltage to the battery terminals but also make use of spark free technology for security.
What happens when a battery is in bulk charge mode?
If the battery is below a certain level of charge, it will activate bulk charge mode, delivering its full charge at a constant rate. Once a certain level is reached, the Battery Tender ® will activate absorption mode, dropping the amps to a lower level for a predetermined period of time or until the optimum voltage level has been reached.
How to troubleshoot a battery tender plus battery?
(A 12 volt battery may not recover from a discharge this deep.) Disconnect all loads from battery (or battery from vehicle), then reattach Battery Tender PLUS. Wait no more than 3 seconds for solid red light. 2 Charger is not properly connected to the battery: rings or clamps are hooked up backwards.
Battery tenders are your ultimate saviors specially in winters when headlights, wipers, and heater are running most of the time. These tenders not only provide continuous voltage to the battery terminals but also make use of spark free technology for security.
What does red light on steady mean on battery tender?
Red Light on Steady –This indicates that the charger is properly charging the battery. Green Light Flashing – With the green light flashing and red light ‘on’, it means that the battery is more than 80% charged and is ready to use. Green Light on Steady –It indicates that the charge is complete.
What should I do if my battery tender Jr is corroded?
If the charger ring terminals, alligator clips, or quick-connect terminals are corroded or damaged or not making full electrical contact, or the battery posts are corroded, then: Disconnect charger cables from battery and clean the battery posts and the charger ring terminals, alligator clips, and/or quick-connect terminals.