How do I fix code P0720?
What Repairs Will Fix P0720?
- Replace output speed sensor.
- Replace input speed sensor.
- Repair or replace damaged wiring and/or connectors.
- Replace the transmission fluid temperature sensor.
- Change transmission fluid and filter.
- Fix transmission fluid leaks.
What does diagnostic code P0720 mean?
output speed sensor circuit
The P0720 code is a standard OBD-II trouble code that detects an issue with the output speed sensor circuit. The powertrain control module (PCM) relies on a signal from the output speed sensor, so that it can determine the correct shift strategy and send that information to the transmission.
Where is the output shaft speed sensor located?
Locate the transmission speed sensors, they’ll be near the front and rear of the transmission housing. Consult the repair manual for your car. Place bucket or oil drain pan underneath the sensor, there will be some oil that drains out.
What does po720 mean?
Diagnostic trouble code (DTC) P0720 stands for “Output Speed Sensor Circuit Malfunction.” It means that the powertrain control module (or transmission control module) perceives a problem with the output speed sensor (OSS) or its circuit.
What are the symptoms of a bad input speed sensor?
5 Common Bad Speed Sensor Symptoms
- Transmission problems.
- Erratic speedometer readings.
- Inability to engage cruise control.
- Lack of torque converter clutch application.
- Check Engine Light is triggered.
- An internal electrical fault in the speed sensor.
- Damage on the sensor itself.
- Poor vehicle maintenance.
What does p0720 mean on a car computer?
Your car computer may display Code P0720 if it detects a problem with the output speed sensor. What Does the P0720 Code Mean? Diagnostic trouble code (DTC) P0720 stands for “Output Speed Sensor Circuit Malfunction.”
Where is the output speed sensor p0720 located?
You’ll commonly see this sensor mounted near the output shaft on the transmission. The P0720 code is activated when the PCM detects insufficient input from the OSS. This code is similar to P0721, P0722, and P0723. P0720 is a common issue among the following makes: Ford (especially a Ford F-150), Nissan, Dodge, BMW, and Honda.
How much does it cost to diagnose a p0720 code?
The cost of diagnosing the P0720 code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How to diagnose a p0720 output shaft malfunction?
Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals. The cost of diagnosing the P0720 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type.