How do I find my Jeep JK engine code?
For JK Wranglers, checking the engine code is a relatively simple task….How to Check An Engine Code
- Insert key into the ignition.
- Turn to “ON” position without starting the Jeep.
- Push the key in and turn it to “OFF” and then to “ON” three times, leaving it in the “ON” position.
What does p0344 mean on a Jeep Wrangler?
P0344 is an OBDII diagnostic code. It is a generic code, which means that it has the same meaning for the Jeep Wrangler as it would any other vehicle. If your Wrangler has this code, it means that the PCM (powertrain control module) has detected that the camshaft position circuit is sending an intermittent signal.
What does the camshaft position sensor on a Jeep Wrangler mean?
It is a generic code, which means that it has the same meaning for the Jeep Wrangler as it would any other vehicle. If your Wrangler has this code, it means that the PCM (powertrain control module) has detected that the camshaft position circuit is sending an intermittent signal.
Why does my Jeep Wrangler have no start?
Check Engine Light – This is often the only symptom of P0344. No Start – Without data from the camshaft position sensor, it’s quite common to get a no start from your Wrangler.
P0344 is an OBDII diagnostic code. It is a generic code, which means that it has the same meaning for the Jeep Wrangler as it would any other vehicle. If your Wrangler has this code, it means that the PCM (powertrain control module) has detected that the camshaft position circuit is sending an intermittent signal.
It is a generic code, which means that it has the same meaning for the Jeep Wrangler as it would any other vehicle. If your Wrangler has this code, it means that the PCM (powertrain control module) has detected that the camshaft position circuit is sending an intermittent signal.
Check Engine Light – This is often the only symptom of P0344. No Start – Without data from the camshaft position sensor, it’s quite common to get a no start from your Wrangler.
Why is my oil pump not working on my Jeep Wrangler?
The cause of the problem was a worn out camshaft synchronizer / oil pump drive assembly. You can tell from the video how loose it is. Keep in mind this is what fires the plugs & injectors (along with the crankshaft position sensor). If you have these codes, do yourself a favor and check this first.