Menu

Navigation

How do I configure Edimax access point?

Posted on by Arif Clayton

How do I configure Edimax access point?

  1. Edimax EW-7416APn. Wireless Access Point. Setup Universal Repeater.
  2. Step 1: Connect EW-7416APn to the computer.
  3. Step 2: Change the IP Address of EW-7416APn (according to. your router’s IP range)
  4. Step 3: Configure Universal Repeater.
  5. Gateway: 192.168.2.1. EW-7416APn: 192.168.2.50.
  6. Gateway: 192.168.2.1. EW-7416APn: 192.168.2.50.

How do I reset my Edimax n300 WiFi extender?

Here’s the steps to reset the unit.

  1. plug the unit into the power outlet and wait for about 30~45 seconds for it to finish booting up.
  2. while it is powered ON, press and hold down the WPS button for at least 20 seconds.
  3. after that, release it and wait for about 30~45 seconds for it to finish booting up again.

How do I reset my Edimax access point?

If you can not get the login page or if you get the login page but username admin and password 1234 failed, you can reset the router to factory default by pressing the Reset button at the back of Access Point for 15 seconds. This will erase all the setting in Access Point and restore the factory default.

Which is the default IP address for Edimax extender?

All the devices in the network have the same first three octets of IP address, but the last octet number must be different. You can keep the Edimax extender with its default 192.168.2.1 address. However, you may want to assign a new IP address to extender. This new IP could be helpful for trouble shooting purpose.

Is the Edimax WiFi router compatible with Windows 10?

Edimax Wi-Fi Routers, Access points, range extenders, Wi-Fi bridges, smart plugs and switches are compatible with Windows 10. For any further questions regarding Windows compatibility please contact Edimax technical support. Edimax cannot access and provide for support for Microsoft drivers in the Windows 10 operating system.

How do I install Edimax on my computer?

Insert the Edimax CD disk that came with the wireless access point. Once you insert the CD disk in, the AutoPlay pops up. Click on “Run Autorun.exe”. If you see a pop up window asking “Do you want to allow the following program to make changes to this computer”, click on Yes to accept.