How do I clear my Nissan self learning?
1.START
- Start engine and warm it up to normal operating temperature.
- Select “SELF-LEARNING CONT” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.
- Clear mixture ratio self-learning value by touching “CLEAR”.
What does code P1273 mean on a 2005 Nissan Altima?
Error Code P1273 is described as Air Fuel Ratio Sensor 1 Bank 1 Lean Shift Monitoring. This refers to a lean condition due to too much oxygen, usually caused by a vacuum leak, fuel pressure, dirty MAF (Mass Airflow sensor), or defective or dirty injectors.
What happens when you change the O2 sensor?
The O2 sensor then sends information to the electronic control unit, or ECU, the vehicle’s computer. The ECU then adjusts the air-to-fuel ratio to optimize the fuel combustion. Sometimes an O2 sensor fails, and you need to replace it.
How to clear the ECU self learning data?
CLEAR THE SELF-LEARNING DATA 1. Start engine and warm it up to normal operating temperature. 2. Turn ignition switch OFF. 3. Disconnect mass air flow sensor harness connector, and restart and run engine for at least 5 seconds at idle speed. 4. Stop engine and reconnect mass air flow sensor harness connector. 5. Make sure DTC P0102 is displayed. 6.
What’s the best way to remove an oxygen sensor?
Unscrew the oxygen sensor off the exhaust pipe using either an open-end wrench or a special socket made to remove it. The majority of oxygen sensors will take an SAE 7⁄8 inch (2.2 cm) wrench.
When do you Know Your oxygen sensor is bad?
The first indication of a problem with your vehicle’s oxygen sensor is often when the “check engine” light comes on. Failing sensors cause jerky movements, trouble starting, and reduced fuel efficiency if they aren’t replaced. Oxygen sensors are necessary for vehicles to combine the proper ratio of gas and oxygen into fuel.
The O2 sensor then sends information to the electronic control unit, or ECU, the vehicle’s computer. The ECU then adjusts the air-to-fuel ratio to optimize the fuel combustion. Sometimes an O2 sensor fails, and you need to replace it.
CLEAR THE SELF-LEARNING DATA 1. Start engine and warm it up to normal operating temperature. 2. Turn ignition switch OFF. 3. Disconnect mass air flow sensor harness connector, and restart and run engine for at least 5 seconds at idle speed. 4. Stop engine and reconnect mass air flow sensor harness connector. 5. Make sure DTC P0102 is displayed. 6.
Unscrew the oxygen sensor off the exhaust pipe using either an open-end wrench or a special socket made to remove it. The majority of oxygen sensors will take an SAE 7⁄8 inch (2.2 cm) wrench.
The first indication of a problem with your vehicle’s oxygen sensor is often when the “check engine” light comes on. Failing sensors cause jerky movements, trouble starting, and reduced fuel efficiency if they aren’t replaced. Oxygen sensors are necessary for vehicles to combine the proper ratio of gas and oxygen into fuel.