How do I change DC priority?
Open regedit or regedt32 on the domain controller and browse to the following key: HKLM\SYSTEM\CurrentControlSet\Services\Netlogon\Parameters. To configure the Priority, add a REG_DWORD with the name LdapSrvPriority. To configure the weight, add a REG_DWORD with the name LdapSrvWeight.
What is domain weight?
By default all Domain Controllers have a weight of 100, the heavier the weight the more often the Domain Controller is referred to. If there are two servers in a site and one has a weight of 100 and the other 200. The Domain Controller with twice the weight will receive twice the referrals.
What is logon server?
If your computer is connected to domain or workgroup then LOGONSERVER means the group or domain to which your computer is connected.
How do I find out what logon server I am using?
Have the logged on user launch the command prompt on the target computer. Type Set Logonserver the name of the domain controller that authenticated the user will be returned. See the figure below. Using echo %username% will allow you create a script to identify the authenticating domain controller.
What is DNS priority weight?
Priority: This parameter is the priority of the target host. A lower value indicates a more preferred priority. The range is 0 to 65535. Weight: This parameter is a relative weight between 0 and 65535 for records with the same priority. Port: This parameter is the port on which the service is found.
Does LDAP need DNS?
Most LDAP clients need to be explicitly configured with the addresses of the LDAP servers to use. However, RFC 2782 describes an alternative way of figuring out what directory servers are available: DNS SRV resource records, also called DNS service records.
Can domain be smaller than range?
Because the domain refers to the set of possible input values, the domain of a graph consists of all the input values shown on the x-axis. Keep in mind that if the graph continues beyond the portion of the graph we can see, the domain and range may be greater than the visible values.
What is reasonable domain and range?
1. With this information we would say a reasonable domain is 0 < c ≤ 119 feet. Similarly for the range, it doesn’t make sense to have negative heights, and the maximum height of a tree could be looked up to be 379 feet, so a reasonable range is 0 < h ≤ 379 feet.
Do you need to change the weight of a domain controller?
In most of the cases, the default domain controllers weight and priority work for all environments. However, you might want to change the default weight and priority of domain controllers based upon your requirements.
How to change the status of a logon?
Remarks Only administrators can use the change logon command. Logons are re-enabled when you restart the system. To display the current logon status, type: change logon /query To enable logons from client sessions, type: change logon /enable
What causes long logon times on DNS server?
If there is an external DNS address in the NIC’s DNS settings (such as the router’s IP address, or your ISP’s DNS servers), then that will *surely* and always cause long logon times. If the DNS addresses are correct, then below are some other things that can cause long logon times.
How to find out what the latest version of Logon is?
To find out what’s new in the latest version, see What’s New in Remote Desktop Services in Windows Server. Displays the current logon status, whether enabled or disabled. Enables logons from client sessions, but not from the console. Disables subsequent logons from client sessions, but not from the console.