How do I adjust the timing on a Honda Civic DX?
Connect a jumper wire between the BRN and GRN/WHT terminals of the connector. Connect a timing light and check timing using the red timing mark. Adjust timing as needed, by turning the distributor counterclockwise to retard the timing, clockwise to retard the timing. Turn engine off, remove jumper wire and install the rubber caps.
Do you need a timing light for a Honda Civic?
This article applies to the Honda Civic (1990-2000). In order to keep your Honda running great, the ignition timing has to be set properly. Symptoms of poorly-set timing include engine pinging, running rich, or running lean. To successfully get this job done you will need a timing light. You can purchase or borrow one.
What should the timing be on a 1989 Honda Accord?
Rotate the distributor to set the timing to 18degrees +/- 2 BTDC (Before Top Dead Center) and retighten the distributor nuts. On the 1989 Honda Accord, 18 degrees is the middle mark (painted red) of the three marks on the crankshaft pulley. The 18 degree mark should be centered in the timing pointer.
How do you check ignition timing on a Honda?
The car must first be warmed up until the fan turns on. Timing marks are exposed by removing the rubber cap from the inspection window on the cylinder block, by the bell housing. Also, the ignition timing check connector must be jumped.
Where is the ignition timing on a Honda Civic DX?
Honda recommends that the ignition timing be checked every 60,000 miles (96,500 km) and adjusted (if necessary). On all Civic series engines the timing marks are located on the crankshaft pulley, with a pointer on the timing belt cover. All are visible while looking at the driver’s side of the engine compartment.
This article applies to the Honda Civic (1990-2000). In order to keep your Honda running great, the ignition timing has to be set properly. Symptoms of poorly-set timing include engine pinging, running rich, or running lean. To successfully get this job done you will need a timing light. You can purchase or borrow one.
What does BTDC stand for in Honda Civic?
BTDC stands for “before top dead center.” If you deem it necessary, you will have to adjust the distributor cap in order to advance or retard the timing. You need to turn the distributor housing towards the firewall to advance the timing and turn towards the front end to retard the timing.
Where is the service connector on a Honda Civic?
The service connector is located on the passenger side. It is underneath the glove box by the kick panel. It’s the same connector used to read check engine lights. You need to disconnect it and put a small wire connecting both sides of the connector in order to short it.