How can you tell if you have a transmission problem?
The first sign that you may have a possible transmission problem could be the check engine light coming on. In other cases, the transmission warning light may come up but not the check engine light, and symptoms such as erratic shifting or delayed shifting become noticeable.
Why is my transmission light still on after replacing it?
If you had your transmission just replaced, then your light may be on for the transmission. The light could still be on for another reason. I would have the system scanned to get the code and see if it is for a transmission problem or for another reason. Sometimes when a major repair is done something can come loose or is not connected correctly.
What happens if you have an automatic transmission problem?
For that reason, here are the list of automatic transmission problems. If there is a mechanical problem with your vehicle, it will start giving distinct sound and lack of response from your vehicle. Not only that, It will release unusual smell of the burning fuel. In electrical problem case, the vehicle dashboard might even starts indicating!
Why did my check engine light come on again?
About two or three months after the catalytic convert was replaced the check engine light came on again. This is around the time I asked for an OBD-II code scanner for Christmas. The same “P0240” trouble code was being stored in the engine control module.
What’s the best way to check a transmission ground?
Check individual chassis grounds by taking a voltage drop across each ground strap on the transmission. Voltage drop should be 0.2 volts or lower. Clean, repair or replace transmission grounds as necessary. Remove grease, rust and paint from under ground terminals, or replace damaged ground straps. V. Why It’s Important to Find and Fix Bad Grounds
What is the code for a transmission failure?
These codes all relate to shift solenoid failure. Your TCM tells your transmission how and when to shift by opening one of these solenoids to allow transmission fluid to pass into the transmission’s hydraulic control section for the specific gear.
How to find a fault in a Chevy transmission?
Reading Chevy transmission codes from the PCM/TCM module requires more than a simple OBD-II scanner. It requires a diagnostic scanner that will retrieve fault codes from PCM such as Foxwell Chevy Transmission Scanner, Launch Transmission ABS Diagnostic Tool, and Autel Transmission Scanner.