How can I tell if my Suzuki indicator light is working?

How can I tell if my Suzuki indicator light is working?

You should have the system inspected by an authorized SUZUKI dealer. For details of the ESP® systems, refer to “Electronic Stability Program (ESP®)” in the “OPERATING YOUR VEHICLE” section. When the ignition switch is turned to the “ON” position, this light comes on briefly so you can check that the light is working.

When to ask a Suzuki dealer to inspect the brake system?

WARNING: If any of the following conditions occur, you should immediately ask your SUZUKI dealer to inspect the brake system. • If the brake system warning light does not go out after the parking brake has been fully released. • If the brake system warning light does not come on when the ignition switch is turned to the “ON” position.

What does it mean when a Suzuki tire light turns off?

Even if the light turns off after blinking, indicating that the monitoring system has recovered, make sure to have an authorized SUZUKI dealer check the system. The load rating of your tires is reduced at lower inflation pressures.

How is the compressor clutch relay turned on and off?

In some vehicles the compressor clutch relay is turned on and off by the low pressure switch and the evaporator temperature sensor. In a computer controlled system, the compressor clutch relay is grounded by the computer. If the fuse is good, disconnect the electrical connector from the compressor clutch coil.

What to do if your Suzuki 1500lc won’t start?

Probably 75% of the people I personally know who own or have owned a pre-2005 1500LC have had this assembly fail on them. By all means check the starter relay- use your multimeter to make sure you are getting power to it, and to check the continuity.

What to do if your fuse box is clicking?

If that relay also clicks constantly, you need to run more tests. If that relay works fine, then the original relay that was in that spot is faulty. Simply replace that relay with a new one. Identify the terminals on the relay. Look at the terminal labels on the relay.

Why is my fuel pump clicking on and off?

If you don’t know how to use a multimeter, St. Lawrence University has published a good tutorial. Dodge trucks built between 1992 and 1995 have a common problem with the PCM. The main computer board cracks, and it causes the ASD and fuel pump to click on and off constantly. Locate the problem relay.