Does the Road King have a fuel gauge?
Plug-&-play direct replacement for the stock fuel gauge with LED fuel level and battery voltage indicators. …
Where is the fuel pump on a road King?
Search videos on YouTube there’s many on how to do it. Replace the check valve/line assembly, fuel filter kit at the same time. You should be able to reuse all gaskets and screws. My 2000 RKC has the 3 wires for the fuel pump running from the seat/battery right under the tank….clearly labeled might be another pinch point.
Why does the Harley Davidson Road King have electronic fuel injection?
One of the pieces of technology that Harley-Davidson employed for the Road King is electronic fuel injection. This accomplishes several different things. First and foremost, it provides an avenue for the motorcycle to have more power than it would otherwise. It also allows it to operate more smoothly.
How does a fuel pump mount on a Harley Davidson?
Fuel pump in unfolded position. Witht he assembly out of the tank, it is obvious how the pump mounts. There is a clamp, or sometimes 2 around the body of the pump holding it in place. Disconnect the wire, and hoses, loosen the clamps, and the pump slides out. Installation is just the opposite. Figure 16.
Can a fuel filter be replaced on a road King?
Going into the fuel tank is easier than you think. The only difficult part is getting the fuel filter assembly to pivot. Search videos on YouTube there’s many on how to do it. Replace the check valve/line assembly, fuel filter kit at the same time. You should be able to reuse all gaskets and screws.
Can a 1998 Harley Davidson Road King fuel pump work?
Fast shipping. According to specifications, fits 1998 Harley Davidson Road King PRODUCT WAS OK. IT MADE MORE NOISE THAN USUAL The fuel pump itself worked properly and continues to do so. But the filter strainer did not fit this pump!The diameter of the filter screen was smaller than the diameter on the pump intake.
Fuel pump in unfolded position. Witht he assembly out of the tank, it is obvious how the pump mounts. There is a clamp, or sometimes 2 around the body of the pump holding it in place. Disconnect the wire, and hoses, loosen the clamps, and the pump slides out. Installation is just the opposite. Figure 16.
Going into the fuel tank is easier than you think. The only difficult part is getting the fuel filter assembly to pivot. Search videos on YouTube there’s many on how to do it. Replace the check valve/line assembly, fuel filter kit at the same time. You should be able to reuse all gaskets and screws.
Why is my fuel pump not working on my Harley?
If you could get a voltage at the relay on the coil side of the relay, it would tell the story. Of course you need to disconnect battery cables at both ends clean, and tighten, Same for grounds remove, clean tighten. Sure sounds like a vibration issue more than a heat issue.